DIGITAL DESIGN + FABRICATION WINNIE CHIU 698653 SEMESTER ONE | 2017
M1 JOURNAL
WEEK ONE PANEL & FOLD
MEASURED ISOMETRIC DRAWING : ANALYSIS 38.5 CM
M
C 0.5
THE FAN WAS TAKEN APART AND EACH COMPONENT WAS INDIVIDUALLY MEASURED. IT WAS CONSTRUCTED WITH FIVE COMPONENTS: [ A ] JOINT [ B ] INNER SPIKES X 27 [ C ] PAPER [ D ] EXTERIEOR SPIKES X 2
0.5
.5
10
THE STRUCTURE IS HELD TOGETHER AT THE POINT OF THE JOINT ALLOWING THE FAN TO OPEN AND CLOSE. THE ATTACHMENT OF THE PAPER TO THE SPIKES AT THE TOP AND ALSO WITH THE EXTERIOR SPIKES RESTAINS THE ANGLES THE FAN CAN OPEN TO. IT’S A COMBINATION OF A SERIES OF PANELS CONNECTED WITH FOLDS ALLOWING THE STRUCTURE TO BE DYNAMIC IN IT’S MOVEMENT. [C] FOLDING COMPONENT
[A] JOINT
[B] INNER STRUCTURE
[D] OUTER STRUCTURE
CM
CM
20 CM
MEASURED ISOMETRIC DRAWING : FAN FIG.2 TOP VIEW 1:2
38 CM
20 CM
TOP FOLDING COMPONENT
STRAP
D BASE
C B
JOINT
A
FIG.1 OPEN VIEW 1:2
FIG.3 CLOSED VIEW 1:2
TECH SESSION: ARCHIMEDIAN SOLID
TOP VIEW
FRONT VIEW
PERSPECTIVE SHADED VIEW
PERSPECTIVE VIEW
WEEK TWO PERSONAL SPACE
DIAGRAM: PERSONAL SPACE
SIDE VIEW
FRONT VIEW
DITIGAL MODEL : FAN
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
TRACE WOOD COMPONMENT AND EXTRUDE.
TRACE PAPER COMPONENT AND EXTRUDE. CREATE A MODULE WHICH CAN BE REPEATED.
CREATE THE JOINT WHICH WILL ALSO FORM THE ROTATION POINT FOR THE FAN
POLAR ARRAY THE MODULE TO FORM THE FAN
APPLY MATERIAL ON EACH COMPONENT
DITIGAL MODEL : FAN
FRONT VIEW
SIDE VIEW
SKETCH MODEL : CONSTRUCTION CREATING EACH MODULE
FOLD IN HALF
CONNECTING EACH MODULE
FOLD IN HALF AGAIN
FOLD ALL CORNER INWARDS
TUCK IN ALL SIDES EXCEPT TOP RIGHT CORNER
EACH MODULAR TRIANGLE IS FORMED BY THREE COMPONENTS
SKETCH MODEL : ANALYSIS THIS MODEL WAS CONSTRUCTED WITH THE USE OF MODULAR ORIGAMI TRIANGLES AND THE SPIRES OF THE FAN. THE TRIANGLES WERE CONSTRUCTED WITH THREE 4CM X 4CM PAPER THAT WERE FOLDED TO FORM A TRAPEZIUM. THEY INTERLOCKED TO FORM A MODULAR TRIANGLE WHERE ONE SURFACE WAS SMALLER THAN THE OTHER. THIS ALLOWED ME TO CREATE 3D GEOMETRY BY EITHER CONNECTING THE MODULAR TRIANGLES WITH EACH OTHER OR WITH THE SPIKES. THE FORM THAT IS SELF SUPPORTING IT’S TRIANGULAR STRUCTURE ACTS AS A BRACE. THE ABILITY TO CREATE FLAT AND CURVED SURFACES GIVES IT A SOLID BASE.. THE LIGHTWEIGHT MATERIAL ENABLES THE CONNECTIONS TO REPLY SOLELY ON ITSELF AND GLUE THAN REQUIRING AN EXTERNAL JOINT.
MODULE [BACK]
MODULE [FRONT]
FRONT VIEW
BACK VIEW
RIGHT VIEW
LEFT VIEW
PANEL & FOLD : SKETCH MODEL 1 PHYSCIAL COMFORT
PANEL & FOLD : SKETCH MODEL 2 PROTECTION
PANEL & FOLD : SKETCH MODEL 3 ISOLATION