Installation Manual
How to install the Planks
Let the planks acclimatize for 24 Hours
Tools needed:
Metal Ruler
Utility Knife
Pencil
Make sure back of the planks and walls are clean and dry
Choose your pattern
1
2
3
4
1
2
3
4
Create starting lines in the middle of your wall
Use WallArt Power Tape
Apply WallArt Power Tape to the back of the Plank
Cut WallArt Power Tape to size with a utility knife
Peel the backing from the WallArt Power Tape
Position the plank along your line
Press the planks into place
How to remove the Tape Put a hair dryer on low heat and point it at the tape, holding it a few inches away. Move the hairdryer over the length of the tape evenly. The heat will loosen the adhesive. Slowly peel off the tape. When the tape is gone, scrub off the sticky residue that remains with a soapy cloth.
How to cut the Planks to size
Measure plank
Mark exact point
Draw cutting line
Cut the plank to size using a metal ruler and a utility knife
Bent the plank gentle till in breaks