BACKSPLASH
INSTALLATION • • • • • • • • •
Use 100% silicone to adhere cut strips and/or full height backsplash to countertop and wall Apply continuous bead at bottom of backsplash, to be adhered to countertop surface Apply continuous 1/8” (3.18mm) beads to backsplash horizontally at bottom, center, and top of backsplash, for full height apply every 8” (203.2mm) Dabs of hot melt adhesive can be used to secure backsplash to the wall while silicone cures Do not hard seam backsplash to countertop All cutouts must have a minimum ¼” (6.35mm)radius Do NOT cut square corners / Do NOT cross corners at corner locations of cutouts Apply 100% silicone around entire perimeter of cutouts on backside to adhere to wall Make sure there is adequate glue squeeze out along entire seam - Check carefully for voids
15
