How Can You Install An Aluminium Composite Panel
Whenever you go to buy an aluminium composite panel, are you confused about how to install it? Don't worry about,aluminum composite materials supplier-Xinghe will tell you how to install an aluminium composite panel .
In order to install aluminium composite panels manufactured and suppliled by aluminum aluminum composite panel suppliers and composite panel manufacturer well, there are several things you need to take into consideration.
First, the aluminum composite plate is connected with another aluminum composite plate or other aluminum composite materials by rivets, bolts, screws, nails, and the like. However, since the surface of the plastic aluminum plate is aluminum, electrochemical corrosion occurs when it is joined to different metal materials. When the back side of the board is in contact with other materials, no surface treatment is required, but aluminum or stainless steel stud bolts or the like are used for the connection between the aluminum composite plates or the board and other aluminum composite materials. When in contact with other different materials (such as steel plates), a protective layer of at least 25u thick should be placed between the contact surface of plastic aluminum plate and the steel plate. A galvanized or insulating material can be used, such as a polyethylene insulating tape between the steel plate and the plastic aluminum plate.
Second, one side of the prefabricated panels with Z-shaped aluminum angle is bonded to the back surface of the prefabricated plate by a high-strength structural adhesive, and the middle edge of the angle material is connected with the bent edge of the plat
Third, fix the pre-made prefabricated panels onto the keel with screws and make sure to adjust the panels to the same level and secure them with rivets and self-tapping screws.
Last, after initial stabilization, it is necessary to pay attention to the neutral weathering sealant reinforcement at the intersection of the keel and the composite board. This directly affects the unreliability. In the splicing, it is necessary to plane the cut so that seams are basically invisible.