Steps to make an RC Air Copter

Steps to make an RC Air Copter 1 Get yourself a small abs plastic or plastic board thin enough that you could drill. Cut the board roughly towards the dimensions two by six inches. Place a plastic tube with the board having a bearing placed each and every finish from the tube. Place the bearings in to the tube first before placing it in to the board piece.

2 Attach two gears towards the board with axles to allow them to spin. Connect one gear towards the tube. Mesh the 2nd gear using the first. Use a solid condition motor close enough around the board to energy the 2nd gear.

3 Adhere the tail from the helicopter towards the body with glue, small screws and nuts. Make use of a small drill to create two holes on both sides from the central board. Connect hanger wire towards the four corners to create the arms of the helicopter's landing skids. Use wire blades to trim the arms to fix length. Connect the finishes from the arms to some lengthy strip of balsa wood on both sides.

4 Place a lengthy fishing rod six inches lengthy with the bearings within the center tube. Permit three inches from the fishing rod to stay from the top. Place a cap on the top of the fishing rod which to connect the rotor base in Step Five.

5 Fabricate a rotor base from the same plastic or abs plastic board materials in Step One. Cut the piece to ensure that they fit to the cap-piece around the rotor axle but additionally has space for that rotor fins. Operate a thinner lengthy fishing rod through this piece verticle with respect towards the rotor axle. Glue the rotor fins towards the horizontal thin fishing rod to create the helicopter fins.

6 Fasten a block of balsa wood towards the finish from the tail structure. Place a fishing rod using it . balsa block. Fasten a tail rotor motor towards the tail finish block. Glue a little fishing rod for this motor's gear after affixing tail fins towards the fishing rod to create the tail fan. Glue all things in place.

7 Glue a receiver to the foot of the helicopter central body or board. Run the wiring in the receiver to both motors - the primary engine and tail engine - for connecting them. Tape four or five AAA size batteries together and fix towards the helicopter body use a energy source. Attach the batteries towards the wiring to ensure that the receiver may be the cutoff and just enables energy towards the engines once the receiver will get the signal to do this.

8 Configure the receiver towards the radio signal of the hands control unit. Test the receiver using the batteries connected to determine it responds accordingly once the controller signals for that system for connecting. Test fly your homemade helicopter.

Would you like to have more article about the RC helicopter ?Visit aurabuy.com.