SPL4/8 DMX512 SIGNAL SPLITTER
USER MANUAL VER: 2.0
Net.DO LIGHTING CONTROL EQUIPMENT CO.,LTD http://www.netdo.com.cn
Net.DO
http://www.netdo.com.cn
Lighting Control Equipment Co.,Ltd
Specification parameter： SPL8
SPL4 DMX512 INPUT
1
1
DMX512 OUTPUT
1
1
ISOLATED DMX512 OUTPUT
4
8
CONNECT SOCKET
XLR-3
XLR-3
Input-Output Isolation Voltage
＞ 2000V
＞ 2000V
ELECTRIC POWER
Switch mode power 100~240VAC，50/60HZ, SOURCE
SOURCE
short-circuit protection & overload protection.
POWER
4W
6W
SIZE
19” 1U
FRONT: Net.DO
OFF
DMX512 SIGNAL SPLITTER 1 DMX INPUT AND 4/8 ISOLATED OUTPUT
ON
Power switch
BACK: SPL4：
POWER IN (AC100~240V)
DMX-IN
PIN NAME: P1 = GND P2 = S P3 = S +
OUT-1
OUT-2
OUT-3
OUT-4
OUT-5
OUT-6
OUT-7
OUT-8
DMX-IN
PIN NAME: P1 = GND P2 = S P3 = S +
OUT-1
OUT-2
OUT-3
OUT-4
OUT-5
OUT-6
OUT-7
OUT-8
SPL8：
POWER IN (AC100~240V)
Power socket
DMX output
SPL4/8 Dmx512 Signal Splitter
DMX input
Isolated DMX output
PAGE: 2
Net.DO
http://www.netdo.com.cn
Lighting Control Equipment Co.,Ltd
Connectďźš z
There are some DMX512 XLR-D3F output sockets on the rear panel of the DMX Splitter, pin1 for signal ground, pin 2 for negative, and pin 3 for positive.
z
DMX512 cable is screened twist line. Each end of the cable should be joined to XLR plug by user. Pin 1of XLR plug is connected to the screen net of the cable. Two lines of twist line (distinguished by different colors) are connected to pin 2 and pin 3 of the plug respectively. Please do not confuse.
LIGHTING CONTROLLER D MX51 2 OUTPUT
DMX SPLI TTER
SCREENED TWIST LIN E
INPUT OUTPUT ISOLATED DMX OUTPUT
FIXTURE
FIXTURE
Fixture or DMX Equipment 2
1 3
FIXTURE
FIXTURE
DM X SPLITTE R INPUT OUTPUT ISOLATED DMX OUTPUT
2
120 OHM TE RMINAL RESISTANCE
Pin number
3
Cable conductor
1
Shield
2
Negative pole
3
Positive pole
SPL4/8 Dmx512 Signal Splitter
1
PAGE: 3