? read these instructions carefully before installing your equipment. ? install the wall bracket in a suitable location using fixing which are appropriate for the
wall material and structure. consult a qualified builder if you are in any doubt as to the structural integrity of the wall. ? do not attempt to alter or modify any part of the wall mount or it's attachments. ? do not use if any parts are broken or appear to be damaged. ? tighten all bolts and fixings securely. only use fixings provided with this bracket. ? do not mount your tv near to sources of heat or moisture. ? always have a minimum of two persons to install the wall bracket and tv.
multi action wall bracket pull out, tilt and swivel medium lcd tv mount model - AB-M203MA
fixing kit
1
attach bracket to tv
a - m4 x 16mm b - m5 x 16mm c - m6 x 16mm
x4
d - m4
x4
f - m6 nut and bolt
x6
g - spanner
x1
note: washer to be used with 4mm bolt only
a-dx4
note: for horizontal fixing points over 200mm use extension plates as shown below
a fx6
SMARTFIT installation helpline 0845 6029217
b
2
3
attach bracket to wall
position 1
attach tv to bracket
top view
side view
note:: ? for ease of installation mount bracket on wall
using position 1 and mark other positions using a spirit level. then remove fixing from position 1, remove bracket and drill other positions. ? fix bracket to wall using wall fixing points from outside inwards to help keep bracket level during installation. ? use fixings suitable for your type of wall construction. ? use all available fixing points. ? if in any doubt of the suitability of the wall, it's construction or what type of fixings to use, consult a qualified builder or installer.
note: ensure hooks have fully engaged onto pivot before releasing the tv. make sure hooks are mounted between the two metal washers either side of the pivot section.
4
secure tv on bracket
note: tighten bolts as shown below to secure tv in position. use all three locking positions
5
adjusting tilt
a
b
adjust tilt loosen tilt bolts and pivot (shown below)
6
c tighten tilt bolts and pivot (shown below)
x2
3
2
3
3
2
2
1
1 note: always loosen pivot to adjust tilt. do not force adjustment whilst pivot in tightened. do not force tilt past 20 degrees downwards stop. always make sure all three locking positions are tight before use.
1
attach trims