? read these instructions carefully before installing your equipment. ? install the wall bracket in a suitable location using fixing which are appropriate for the wall material and structure. consult a
qualified builder if you are in any doubt as to the structural integrity of the wall. ? do not attempt to alter or modify any part of the wall mount or it's attachments. ? do not use if any parts are broken or appear to be damaged. ? tighten all bolts and fixings securely. only use fixings provided with this bracket. ? do not mount your tv near to sources of heat or moisture. ? always have a minimum of two persons to install the wall bracket and tv.
multi action wall bracket tilt and swivel small lcd tv mount model - AB-S102TS
fixing kit
1
attach bracket to tv
a - m4 x 16mm b - m5 x 16mm c - m6 x 16mm
d - m4
f - m6 nut and bolt
g - spanner
x4 x4 x6
note: washer to be used with 4mm bolt only
a-dx4
x1 note: for horizontal fixing points over 200mm use extension plates as shown below
a
fx6
SMARTFIT installation helpline 0845 6029217
b
2
3
attach bracket to wall
position 1
attach tv to bracket
top view
note:: ? for ease of installation mount bracket on wall using
position 1 and mark other positions using a spirit level. then remove fixing from position 1, remove bracket and drill other positions. ? fix bracket to wall using wall fixing points from outside inwards to help keep bracket level during installation. ? use fixings suitable for your type of wall construction. ? use all available fixing points. ? if in any doubt of the suitability of the wall, it's construction or what type of fixings to use, consult a qualified builder or installer.
4
secure tv on bracket
5
side view
note: ensure hooks have fully engaged onto pivot before releasing the tv. make sure hooks are mounted between the two metal washers either side of the pivot section.
adjusting tilt
a
b
c
loosen pivot
adjust tilt
tighten pivot
note: tighten bolt as shown below to secure tv in position.
6 x2
note: always loosen pivot to adjust tilt. do not force adjustment whilst pivot in tightened. do not force tilt past 30 degrees downwards stop.
attach trims