MEDIA STORAGE MODELS: ASPM-G, W, LO & B
ASSEMBLY INSTRUCTIONS
IMPORTANT INFORMATION! 1) Before starting assembly please take time to familiarise yourself with the instructions and the components listed on the following page, as this product could be unstable if incorrectly installed. 2) Do not place hot or cold items against or in close proximity to any glass surface unless an adequately thick insulating material is used to prevent such items coming into contact with the glass. 3) Do not strike the glass with hard or pointed items. 4) When cleaning glass panels use a damp cloth or leather with washing up liquid or soft soap if necessary; do not use washing powders or other substances containing abrasives as these may scratch the glass. 5) In order to maintain a high quality finish, when cleaning wooden panels please use a soft cloth with a suitable furniture polish if required. 6) Alphason Designs uses real wood veneers, consequently slight colour and pattern variation may occur and does not indicate a product defect. With natural wood, exposure to direct sunlight can produce colour change and should be avoided. Any slight change in colour over time does not indicate a product defect. Please Note: This support must be assembled in accordance with these assembly instructions. Alphason Designs Ltd. accepts no liability for any damage caused through incorrect or inappropriate use of this media storage.
Alphason Designs Limited Alphason House, Bolton Road, Atherton, Greater Manchester M46 9AW UK Tel: +44 (0)1942 885600 Fax: +44 (0)1942 876955
www.alphasondesigns.com
issue 03 09/07
STAGE 1
B
1.
• Position side panel
B D
• Assemble tubes
1a. Right Panel
C
E
B
E
Raised portion of washer
A
on its longest edge on a clean, flat surface to prevent scratching. Please note: Black option side panels are labelled L and R to denote left and right.
A
B , washers C
and end caps D using screws E . Do not fully tighten screws at this stage. Ensure that the raised portion of washers C locate correctly into tube ends.
• Figure 1a shows the position of washers C (reverse side of side panel shown).
2.
STAGE 2 A
• Attach second side panel
as per
Stage 1. Do not fully tighten screws at this stage as this makes it easier to insert plastic washers
C
Right Panel
.
C
3.
Left Panel
STAGE 3 • With second side panel in position, place assembly in upright position. Tighten all screws using allen key G . Ensure that all screws are centrally located in end caps D .
F
• Attach cover caps caps by hand.
F
into threaded ends of screws
E
. Tighten cover
issue 03 09/07
MODEL: ASPM-G, W, LO & B CERTIFICATE OF CONFORMITY C O M P O N ENT
A
Raised portion
QTY
DESCRIPTION
SIDE PANEL
WALNUT LIGHT OAK BLACK- LEFT & RIGHT GLASS
PACKED BY
2
B
CHROME TUBE
15
C
PLASTIC WASHER
30
D
END CAP
30
E
SCREW
30
F
COVER CAPS
30
G
ALLEN KEY
1
issue 03 09/07
Alphason Designs Limited Alphason House, Bolton Road, Atherton, Greater Manchester M46 9AW UK Tel: +44 (0)1942 885600 Fax: +44 (0)1942 876955
www.alphasondesigns.com