ULTRAVIOLET WATER STERILIZER USER'S MANUAL
REMINDER
BALLAST
1. Before installation, make sure your local electricity is 230V/50Hz. Incorrect voltage or unstable current may cause damages to the fuses. 2. When the ballast ceases to function, check and change fuse no.1 (Figure 1). 3. If the ballast remains out of order, use a screwdriver to open the ballast and change fuse no. 2 inside. 4. If you are not familiar with changing the fuse, or after changing both fuses the ballast is still not working ( IC board could be damaged ), contact your local service center or distributor for service.
FUSE NO.1
Figure 1
INSTALLATION PROCEDURE
TROUBLE SHOOTING 1. If neither lamp on the ballast is on, check if power plug is well connected. 2. If lamp red is on with buzzer, a. disconnect the power plug. b. loosen end cap. c. check if uv lamp plug is connected well with the lamp pins. d. reinstall the uv water sterilizer. e. after a while's usage, if lamp red is on with the plug well connected, consult your local service center or distributor for replacement of UV lamp.
1. Loosen the End Cap on the right side. 2. Put the UV Lamp inside the Quartz Sleeve. 3. Connect the four pins of UV lamp with the UV lamp plug. 4. Screw the End Cap. 5. Put on the protective cover. 6. Repeat step 1~5 when there is more than one UV lamp. 7. Connect Inlet / Outlet port with Tubing. 8. Plug in the power line and check on the lamps on the Ballast (step 1~8, Figure 2). remarks: 1. When lamp green is on: normal. 2. When lamp red is on with buzzer: lamp failure. 3. Each of 2 or 3 can be inlet or outlet.
2 OUTLET (INLET)
3 INLET (OUTLET)
8 PROTECTION COVER
4 QUARTZ SLEEVE
5 UV LAMP
7 END CAP
NORMAL
FAIL
1 STAINLESS STEEL UV VESSEL
Figure 2
11 POWER PLUG W/GROUNDING
10 BALLAST & INDICATORS
9 WIRE
6 UV LAMP PLUG