International Conference on Advances & Challenges in Interdisciplinary Engineering and Management
46
International Conference on Advances & Challenges in Interdisciplinary Engineering and Management 2017 [ICACIEM 2017]
ISBN Website Received Article ID
978-81-933235-1-9 icaciem.org 10 – January – 2017 ICACIEM091
VOL eMail Accepted eAID
01 icaciem@asdf.res.in 28 - January – 2017 ICACIEM.2017.091
A Wireless Battery Charger for Mobile Device 1,2,3,4
G Senthil Kumar1, G S Sukanth2, P Prem Kumar3, V Benjamin Sam4 III-Year Students, Department of EEE, Vidyaa Vikas College of Engineering and Technology, Tiruchengode, India
Abstract: In this paper, an innovative design of a wireless battery charger for portable electronic devices is proposed. The wireless power transfer is implemented through the magnetic coupling between a power transmitter, which is connected to the grid, and a power receiver, which is integrated inside the load device. An innovative receiver architecture which heavily Improve the power conversion efficiency is presented. A laboratory prototype of the proposed wireless battery charger has been realized and tested to evaluate system performances. Over the entire range of operating conditions the receiver efficiency lies within the 96.5% to99.9% range.
ISBN Website Received Article ID
978-81-933235-1-9 icaciem.org 10 – January – 2017 ICACIEM092
VOL eMail Accepted eAID
01 icaciem@asdf.res.in 28 - January – 2017 ICACIEM.2017.092
Noise Reduction and Material Inspection by using Geneva Conveyor K Selvaraj1, R Silambarasan2, K Sivamani3, M Sridharan4, P Srinivas5 1,2,3,4,5 UG Students, Department of Mechanical Engineering, Vidyaa Vikas College of Engineering and Technology, Tiruchengode, India Abstract: In our project we are using the Geneva conveyor for material handling and noise lessening in industries. It consists of motor, rollers, belt and IR sensor. Two rollers are mount on the situate, according to the necessary remoteness. The belt is mounting on the rollers on which the materials are located. The roller shaft is coupled with the Geneva drive. The Geneva drive shaft is coupled by means of the motor shaft, hence when power is supplied to the motor the rollers turn around with a certain time stoppage according to the Geneva drive and the belt moves the length of the rollers. Thus material handling is carried out. With the help of Geneva drive, the time stoppage can be achieved which avoids the use of stepper motor thus reduces the cost concerned. The main aim of this project is to optimize the measuring distance end to end of work piece and to decrease the sound of conveyor. In general the plug gauges are used to examine the components. Instead of using manual inspection, automatic system via pneumatic comparators is used.
This paper is prepared exclusively for International Conference on Advances & Challenges in Interdisciplinary Engineering and Management 2017 [ICACIEM 2017] which is published by ASDF International, Registered in London, United Kingdom under the directions of the Editor-in-Chief Dr K Samidurai and Editors Dr. Daniel James, Dr. Kokula Krishna Hari Kunasekaran and Dr. Saikishore Elangovan. Permission to make digital or hard copies of part or all of this work for personal or classroom use is granted without fee provided that copies are not made or distributed for profit or commercial advantage, and that copies bear this notice and the full citation on the first page. Copyrights for third-party components of this work must be honoured. For all other uses, contact the owner/author(s). Copyright Holder can be reached at copy@asdf.international for distribution.
2017 © Reserved by Association of Scientists, Developers and Faculties [www.ASDF.international]
`