bdf_p_is_machine

I.S.-P MACHINE PARALLEL MOULD MOTION I.S. MACHINE

I.S.-P MACHINE General Data

Application

• Blank mould support with parallel linear motion of the mould holders • Blow mould support with parallel linear motion of the mould holders • Use of standard section frame and lower plate for blank application only (special upper plate) • Use of modified section frame with modified lower and upper plate for blank and blow

• Use of standard blank M.O.C. Mechanism and cylinder for blank parallel support • Use of modified blank M.O.C. Mechanism for blow parallel support • Use of standard moulds assemblies • Blank Mould Opening = 160 mm • Blow Mould Opening = 153 mm • 360° blank axial cooling type “BDF Dual-Axial Cooling” • 360° blow axial cooling type “BDF Dual-Dxial Cooling” or axial cooling through the bottom plate mechanism • Available for DG 5” - DG 5”1/2 - DG 6”1/4 - TG 4”1/4

• Less mould equipment wear • Better moulds clamping • Better cooling • Easy mould change • Easy assembly of mould cooling

Application on Existing Machines • Blank Parallel Mould Support can be installed on 5”1/2 – 6”1/4 existing machines fixing the support with only 4 screws instead of 6 and adding 3 lubrication injectors outside of the section frame (the oil will be feed to the support from outside instead of trough the upper plate).

• Blow Parallel Mould Support can be installed on existing machine changing the lower and upper plate with the M.O.C. mechanism and modifying the section frame drilling.

I.S.-P Machine Mould Cooling • Advantage of equal cooling condition in the two cavities of the mould • Air feed to the wind-box with telescopic pipe and spheric joint • Dual axial cooling system is integrated with the parallel mould opening-closing mechanism • More than 50% of cooling air saving compared with the standard cooling • Possibility of 360° mould cooling • Possibility of mould cooling from the middle of the mould to the top and to the bottom • Use of standard mould assembly (all the existing mould equipment is still used) • On blow side it is possible to use the axial bottom plate mechanism instead of dual-axial

Open Position

Close Position

Assembled in one DG 6”1/4 test section module

BDF in the world

companies representative offices

MOSCOW

MÜNCHEN

SHANGHAI MEXICO CITY

foshan

BDF CZECH

BUENOS AIRES

MCR SYSTEMS

BDF

BDF SERVIS

TDE MACNO

www.bdf.it BDF INDUSTRIES S.p.A. - Head Office and Sales Department Via dell’Industria, 40 - 36100 Vicenza - Italy phone +39 0444.286.100 - fax +39 0444.286.299 - e-mail: bdf@bdf.it

studiobrand.it

GTECH