EutecTrode-Super-110

A Premium, High Strength Low Hydrogen Products with Advanced Impact Resistant Properties

EutecTrode Super 110 ®

WELDING • For critically stressed applications • Premium high strength, low hydrogen electrode • Advanced impact properties • Excellent for welding construction steels

DESCRIPTION:

WELDING PARAMETERS:

EutecTrode Super 110 is formulated for welding critically stressed fabrications where high impact properties are needed and where the weldment is under severe restraint.

Used with low-to-medium carbon steels and HSLA steels of similar strength.

Preparation: Clean weld area of scale and/or oxide. Bevel or chamfer heavy sections to have either a single or double 60° “V” prep. A nominal preheat of 150°F is advised if part is below 40°F or over 1” thick. For higher carbon steels higher preheats will be needed. Check the Reference Section of the Eutectic Coproration Technical Data Book for information regarding specific preheating levels for specific steel grades.

TECHNICAL DATA: Typical Tensile Strength: 110,000 psi 759 N/mm2 Typical Yield Strength: 98,000 psi 676 N/mm2 Typical Impact Strength: Minimum Charpy V-notch @-60°F: 45-60 ft-lb Current & Polarity: DCEP (+) and AC

Technique: All low-hydrogen electrodes should be used with a non-contact, short arc gap technique. Deposit stringer beads or 2x to 3x weave beads. Back whip craters to reduce crater cracking tendencies. When de-slagging make sure to thoroughly remove slag at the weld deposit toes.

Availability and Recommended Amperages

Post-welding: Allow parts to slow cool in still air. High carbon steels should covered with a heat-retardant blanket.

Dia.

1/8“ - 3.2mm

5/32“ - 4.0mm

3/16“ - 4.8mm

Amp.

60-100

110-145

140-210

TYPICAL APPLICATIONS: Use when welding constructional steels where advanced crack-resistance is critically important.

• Tank building • Earthmoving Equipment • Construction Equipment • Steel-Mill Ore Cars

YOUR RESOURCE FOR PROTECTION, REPAIR AND JOINING SOLUTIONS Eutectic Corporation N94 W14355 Garwin Mace Drive Menomonee Falls, WI 53051 USA P 800-558-8524 • F 262-255-5542 www.eutecticusa.com

Eutectic Canada 428, rue Aime Vincent Vaudreuil-Dorion, Quebec J7V 5V5 Phone: (800) 361-9439 Fax: (514) 695-8793 www.eutectic-na.com

Eutectic Mexico KM 36.5 Autopista Mexico-Quertaro 54730 Cautitlan-Izcalli Estado de Mexico, Mexico Phone: 011 (52) 55-5872-1111 e-mail: eutectic@eutectic.com.mx

Statement of Liability: Due to variations inherent in specific applications, the technical information contained herein, including any information as to suggested product applications or results, is presented without representation or warranty, expressed or implied. Without limitation, there are no warranties of merchantability or of fitness for a particular purpose. Each process and application must be fully evaluated by the user in all respects, including suitability, compliance with applicable law and non-infringement of the rights of others, and Eutectic Corporation and its affiliates shall have no liability in respect thereof.

110-02-14-12© 2008, Eutectic Corporation, ® Reg. T.M., Printed in the U.S.A.