Need Of Commercial Air Conditioning Equipment On a hot summer day, an air conditioner is our basic requirement. Due to the inappropriate operation of AC, its parts and equipment are prone to damage every now and then. The improper functioning of your Commercial air conditioning equipment can be reckoned to damaging of parts. Defective parts like faulty motor, choked capillary, bad thermostat, defective control board, or fault in compressor etc. can cause technical issues that lead to an inoperative AC. These are some equipment faults that can be resolved by changing the required part.
1. Congested air filter Continuous use of AC needs incessant filter usage, this way air filters get blocked by dirt and dust, thus hindering the passage of air through filters. A jammed evaporator coil freezes and this affects the cooling capacity. To resolve this issue filters need to be cleaned or changed. Cleaning filters can give you short-term relief, but if you want to rest assured for long, getting filters changed is the only option. 2. Thermostat Sensor Issue Thermostat sensor senses the temperature of the room by measuring temperature through the evaporative coil and guides the compressor to process cooling cycle. It is placed at the back of
the control panel. It should be adjusted very carefully near the coil as with any change in position of sensors, the air conditioner starts behaving erratically thus effecting cooling cycle. 3. Leaks in Refrigerant Low refrigerant charge is apparent when frost appears on outside unit as well as the refrigerant line. It makes bubbly sounds while functioning. There could be two factors that could be reckoned for this issue • Low charge at installation • Leaking duct Leaks could be fixed by expert technicians by analyzing the overall unit and charging it with the dedicated amount of refrigerant as per manufacturer's specification. These leaks could harm the environment so should be repaired at earliest. 4. An inefficient compressor If the compressor stops working, air cooling is not possible as it circulates the air inside out and vice versa. To relive this, getting compressor replaced is the only solution. It’s a motor which allows the refrigerant to flow through the condenser and evaporator coils after compressing the refrigerant or coolant. Faulty remote, under or oversized AC, high atmospheric temperature, insufficient coolant, electric control breakdown, drainage issues, inadequate maintenance are the major problems faced when an AC runs out of service. For a healthy working of AC, buy Commercial air conditioning equipment as per the model and ask for suggestions from the dealer to get the best.