Settings Separation

De-awning

The rotor cover plates can be opened or closed during threshing. The cover plates should be open when maximum separation is needed.

Tips:

If the combine is fitted with 4D SEPARATION, there are now four sets of doors. They can be operated in the same manner as the standard rotor cover plates. Either from the armrest or from the CEBIS screen.

In situations where the straw is breaking up, it may be beneficial to close the rotor cover plates to reduce the sieves being overloaded. To find the correct rotor speed, start with the CLAAS settings in CEBIS and then adjust the rotor speed to suit the conditions on the day.

The straw will only travel along the rotor at one speed. This will differ for every crop, machine and condition.

Depending on the machine, there can be 2 sets or 4 sets of rotor cover plates.

These are opened or closed in CEBIS or on the armrest.

AUTOSLOPE and 4D are activated in CEBIS.

The preparation pan is the first part of the cleaning system that the grain will come into contact with. Its function is to separate the grain and the chaff. The grain is heavier and therefore goes to the bottom, the lighter chaff goes to the top.

Cleaning

Settings

Tips:

Clean the preparation trays daily, this will help keeping a clean sample.

When removing the prep trays for cleaning, blow off the top of the gear box area to remove any chaff and dust.

It is important that this is kept clean, to allow this to happen effectively. A dirty preparation pan will cause a poor sample and reduce output.

Depending on machine type, it may be fitted with either 5 or 6 preparation trays.

Hybrid TRION trays are the same size, therefore can be located into any of the available slots.