Digital Solutions CRUISE PILOT Symbols

The maximum layer height is reached

The cleaning system loss limit is reached

Maximum diesel engine output utilisation is reached The diesel engine protection has responded

The maximum pre-set throughput is reached

The returns grain limit is reached

The returns volume limit is reached

Adaption: The machine adapts to new harvesting conditions

The maximum pre-set ground speed is reached

The unloading mode is activated

The separation loss limit is reached

The turning area is identified

The symbol displayed in “4” is the limiting factor of CRUISE PILOT.

Now adjust the relevant limiting value.

To set throughput with monitoring, drive the combine into the standing crop so that the loss monitors are full to the white line. Then check that this is what you accept as a loss.

During unloading, the CRUISE PILOT automatically changes to unload mode which gives a constant speed, this will can be up to 15% less than the current forward speed. The unload mode can be turned off in CEBIS. Use the QR code on the back of the booklet to get the video for setting up CEBIS in the field.

When changing the crop type, make sure that CEMOS is not available for all crop types.

Grain

No Flex, Rigid Cutterbar using sensor bands for AUTO CONTOUR detection.

Flex Manual

Full Flex Cutterbar knife but with a set level AUTO

CONTOUR

Laid Crop Small Grain Flex

Switching between Grain and Flex modes when change is required on the move (from standing too laid crop).

AUTO Flex

Full Flex with fully adjusting AUTO CONTOUR, Cutterbar is moving both knife and feederhouse, AUTO FLEX try’s to always cut at the lowest possible ground point, best for short crops.