199-01 Exam Practice Tests For Quick Preparation

Questions And Answers PDF

Riverbed 199-01 Riverbed Certified Solutions Professional- WAN Optimization

Version: DEMO

http://www.TestWarrior.com/199-01-practice-exam.html

FOR 199-01 Candidates: We offer Two Products:  1st - We have Practice Tests Software with Actual Exam Questions  2nd - Questions and Answers in PDF Format.

Try a Free DEMO of these Exam Products via below Link:

http://www.TestWarrior.com/199-01-practice-exam.html

TestWarrior.com

1

Questions And Answers PDF

Question 1 Which of the following interface IP addresses can be connected to for management purposes? 1) WAN Interface 2) LAN Interface 3) Primary Interface 4) AUX Interface A. 1,2 B. 2,3 C. 3,4 D. 1,2,3 E. 1,2,3,4

Aoswern C Question 2 What is the default authorizaton policy used by Steelhead appliances?

A. Remote-Last B. Local-Only C. Local-First D. Remote-Only E. Remote-First

Aoswern E Question 3 In version 3.x. actvely synchronizing the data store in an actveepassive mode where one Steelhead is optmizing and replicatng its datastore to the passive Steelhead appliance is called 1) Fail-Over 2) Connecton Forwarding 3) Serial Cascading 4) Parallel Cascading 5)Never A. 1 B. 2 C. 3,4 D. 3,4,5 E. 1,2,3,4,5

Aoswern A Question 4 When troubleshootng a data store wrapping alarm with 1 day wrapping noticaton conigured,

TestWarrior.com

2

Questions And Answers PDF

which of the following should be examined? (Multple answers) A. If the unit wasmis-sized B. If stream based encrypted trafc is being sent across the link as optmized C. Ifyour ixed target rules are pointng to the correct Steelhead D. If Connecton forwarding was properly conigured

Aoswern A,B Question 5 Which of the following may be caused by reasons other than route asymmetry?

A. Receiving a RST packet from the client with an invalid sequence number while the connecton is in the SYN_SENT state B. Receiving a SYNeACK packet from the server with an invalid ACK number while the connecton is in the SYN_SENT state C. Receiving an ACK packet from the client while the connecton is in the SYN_SENT state D. Receiving SYN retransmits from the client

Aoswern D Question 6 Under what circumstances will the Netlow cache entries fush (transmited to the collector)?

A. When the TCP FIN bit is set.

B. When the TCP PSH bit is set.

C. When the TCP RST bit is set.

D. A and C. E. A and B. F. None of the above.

Aoswern A,D Question 7 You would like to mark the DSCP value for an actve FTP data connecton as AF22. Which of the following are true? (Hint Use calculator) A. Specifyqos dscp rule at client-side Steelhead with a dest-port of 21 and with a DSCP value of 22.

B. Specifyqos dscp rule at client-side Steelhead with a src-port of 20 and with a DSCP value of 20.

C. Specifyqos dscp rule at server-side Steelhead with a dest-port of 21 and with a DSCP value of 22 D. Specifyqos dscp rule at client-side Steelhead with a dest-port of 20 and with a DSCP value of 22.

E. Specifyqos dscp rule at server-side Steelhead with a dest-port of 20 and with a DSCP value of 20.

TestWarrior.com

3

Questions And Answers PDF

Aoswern E Question 8 Which of the following demonstrate a valid use of a Peering role?

1) To allow auto-discovery probes to pass through speciic Steelhead appliances 2) To avoid adding auto-discovery probe to a SYN packet 3) To avoid "back to back" or unintentonal cascaded optmizaton in serially clustered deployments 4) To specify a speciic target Steelhead for optmizaton 5) To allow hybrid mode to functon correctly A. 1,3 B. 2,3 C. 1,2,3 D. 1,2,3,4 E. 1,2,3,4,5

Aoswern A Question 9 When cabling a Steelhead for a virtual in-path deployment using WCCP nr PBR, only the following physical interface is required tube wired fur intercepton (assume a single 2 part card in the unit) A. wan0_0 B. lan0_0 C. primary D. aux E. inpath0_0

Aoswern A Question 10 A customer is reportng higher than normal CPU utlizaton on certain routers in their network.

Looking at their Steelhead logs, they see "intercepyelocalkerneleicore.c:1463] nat_check SYN packet for already nated connecton 100.100.100.33:1611 -> 100.200.200.32:80 ==> 100.201.201.25:7801".

All connectons are showing up optmized but the logs persist. Give the following diagram, what is the likely problem?

A. Lost Opportunistc Lock B. SMB Signing C. Fixed-Target rule needed D. Asymmetric Route E. Packet Ricochet

Aoswern E

TestWarrior.com

4

Questions And Answers PDF

Question 11 Which of the following is NOT supported in Alarm SeBings?

A. Raise alarm when network interface duplex errors ore detected B. Raise alarm when network interface link errors are detected C. Raise alarm when the number of optmized connectons exceeds user speciied limit D. Raise alarm if a sofware version mismatch is detected in the network E. Raise alarm when asymmetric routes are detected

Aoswern C Question 12 The Primary interface is REQUIRED for which deployment methods and features?

1) In-Path 2) Server Side Out-of-Path 3) Logical In-Path (WCCPePBR) 4) Hybrid Mode 5) Primary Pile Services (PES) A. 2 B. 1,2 C. 2,3 D. 2,4 E. 24,5

Aoswern E Question 13 In coniguring failover setngs, which of the following interfaces is used for communicatng with the backup Steelhead?

A. inpath0_0 B. inpathl0_1 C. Primary D. AUX E. None of the above

Aoswern D Question 14 A customer has a server side out of path deployment, as shown in the accompanying diagram, and reports hat connectons from some of their remote branch ofces are not being optmized. What is the most likely problem? Server Side Out-of-Path A. A missing Fixed-Target rule on the Server-Side Steelhead

TestWarrior.com

5

Questions And Answers PDF

B. A missing Fixed-Target rule on the Client-Side Steelhead C. The WAN interface is connected to the Server-Side Steelhead D. The LAN interface is connected to the Server-Side Steelhead E. Using port 78t0 in the Fixed-Target instead of 7800

Aoswern B Question 15 In order to achieve optmizaton using auto-discovery for trafc coming from site C and destned to site A in the exhibit, which coniguraton below would be required?

A. In-path ixed target rule on site B Steelhead pointng to Site A Steelhead B. Peering rule on site B Steelhead passing through probes from site C C. Peering rule on site B Steelhead passing through probe responses from site A D. Both Aand C E. Both B and C

Aoswern B

TestWarrior.com

6

Questions And Answers PDF

Thank You for Trying Our Product Visit Our Site to Purchase the Full Set of Actual 199-01 Exam Questions With Answers.

http://www.TestWarrior.com/199-01-practice-exam.html We Also Provide Practice Exam Software That Simulates Real Exam Environment And Has Many Self-Assessment Features. Download Free Product Demo From:

Download Free Product Demo from: http://www.TestWarrior.com/199-01-practice-exam.html

Check Out Our Customer Testimonials

TestWarrior.com

7