Composite Research of RMIT Meeting Pavilion Architecture Elective Tutors: Roland Snooks Marc Gibson
Darren Soh Shi Yang s3525149
Cover images courtesy of Roland Snooks, http://www.rolandsnooks.com/#/meeting-pavilion/
Inlay Cap Design(Blue) Unrolled Inlay: Red lines in unrolled linework represent panel divisions - this is where the cap should cover.
DARREN SOH SHI YANG_S3521549
Inlay Cap Design Outline Draft
Front 1
Front 2
Front 3
Back 1
Back 2
Back 3
DARREN SOH SHI YANG_S3521549
Inlay Cap Design Extracted Unrolled Inlay Revision
DARREN SOH SHI YANG_S3521549
ZOOM
ZOOM
Inlay Cap Design Inlay Offset for Edge Chamfering Bolts Location
DARREN SOH SHI YANG_S3521549
INLAY:
CAP (narrower):
Inlay Cap Design Separated Inlay and Cap: Cap remapped onto smaller surface which was properly offset inwards to match curvature in turning corners.
DARREN SOH SHI YANG_S3521549
Inlay Cap Design Proposed Split: Split Cut for Fitting Into Material Sheet
DARREN SOH SHI YANG_S3521549
Inlay Cap Design
Mapped Inlay Cap on Surface
DARREN SOH SHI YANG_S3521549
15mm Polystyrene Foam (for flat panel) Sanding off sharp corners from CNC cut foam to create chamfered edges to allow tight gap when laminating. DARREN SOH SHI YANG_S3521549
15mm Polyurethane Foam (for curved panel, allow bend) Sanding off sharp corners from CNC cut foam to create chamfered edges to allow tight gap when laminating & taging. DARREN SOH SHI YANG_S3521549
15mm Polystyrene Foam (for flat panel) Gold Spray Painted
DARREN SOH SHI YANG_S3521549
15mm Polyurethane Foam (for curved panel, allow bend) Gold Spray Painted
DARREN SOH SHI YANG_S3521549
15mm Polyurethane Foam (for curved panel, allow bend)
Second layer coating as Polyurethane Foam absorbs Gold Spray Paint. Preventing the results of faded Gold finishes. DARREN SOH SHI YANG_S3521549
2mm Gold Fiberglass Sanding off burnt edges from lasercutting process. Unclean dirt would mess up glueing process of firberglass with foam.
DARREN SOH SHI YANG_S3521549
Paring Fiberglass to Foam covering Foam Joints.
DARREN SOH SHI YANG_S3521549
Curved Panel Gleuing Fiberglass with Polyurethane Foam. Letting it dry in precasted jig/mould to create curvature.
DARREN SOH SHI YANG_S3521549
Laying out Dried Glued Fiberglass and Foam. Send off for lamination by boat manufaturer. DARREN SOH SHI YANG_S3521549
END OF FOLIO
Darren Soh Shi Yang s3525149