Tips for making stamped jewelry

Tips for making stamped jewelry People today spend large sums of money purchasing accessories that can help them enhance their beauty. This has in turn led to the creation of different types of jewelries, some of which are extremely expensive. Among the most common jewelries today are the personalized ones.

These accessories are sold at very high prices especially because of the intense work that is required to design them. Therefore you should be prepared to cough up a considerable amount of cash on your hand stamped jewelry. However, you can save this money by designing your own stamped necklace. Although it may seem difficult, it is actually very simple. The most important thing is to learn the few important steps you are required to take when stamping your jewelry.

When it comes to designing your own stamped jewelry, you need to select the right tools. These tools are extremely important for making the entire process effective. Before you embark on designing the actual stamped jewelry, it is important to do a little practice using a piece of metal.

It is recommended that you use a piece of copper for your practice because it is readily available and it is easy to design. It is very easy to get a piece of copper in craft stores. The most important thing is to know how to space your letters creatively. This might prove to be a bit tough for starters but you will get used to it after a few tests. It is also important to understand the required amount of energy to be applied when designing a stamped jewelry. Too much power may destroy the stamp. But this depends on the piece of metal you want to strike the stamp on. Harder metals may require you to apply more energy to make the stamp visible.

Once you have got your practice stamped jewelry, place it on the block. Then, select the right stamp. The letter angle should be placed in the appropriate position. You should also note that it is not a must that the stamp design be centered on your shank. Experts advise you to make your stamp placement more effective by allowing letter reflections to guide you. Pay attention to the angle of the letter as reflected on the metal. This angle will show you where the letter will fall. The main objective is to have a perfect hit on the stamp bar. But you should be careful because if you whack the stamp bar a lot it might become soft and fail to hold oxidation properly.

Once you have done enough practice, proceed to choose your favorite design. Depending on your design, take your measurements. Also, put a visible mark on the position where you want to place your stamp. If the stamp is going to be in the middle of your stamped jewelry, then you have to work from the middle out. It is also important to draw the required design on paper. This will act as your guide when you are designing the stamp on the final stamped jewelry.