The ERA Bulletin 2012-02

Page 1

The Bulletin

ERA BULLETIN - FEBRUARY, 2012

Electric Railroaders’ Association, Incorporated Vol. 55, No. 2 The Bulletin Published by the Electric Railroaders’ Association, Incorporated, PO Box 3323, New York, New York 10163-3323.

For general inquiries, contact us at bulletin@ erausa.org or by phone at (212) 986-4482 (voice mail available). ERA’s w e b s i t e i s www.erausa.org. Editorial Staff: Editor-in-Chief: Bernard Linder News Editor: Randy Glucksman Contributing Editor: Jeffrey Erlitz Production Manager: David Ross

©2012 Electric Railro a d e rs’ Association, Incorporated

In This Issue: History of the A Train ...Page 2

February, 2012

THIRD AVENUE’S POOR FINANCIAL CONDITION LED TO ITS CAR REBUILDING PROGRAM 75 YEARS AGO (Continued from January, 2012 issue) In the early 1930s, the company was operating approximately 800 cars on 250 miles of track. Most of the fleet was composed of obsolete slow wooden two-motor double-truck cars built in 1908, 1909, and 1911. The 100 single-truck convertibles built in 1914 and 1924 were uncomfortable; their front and rear platforms bounced when the car was running. But the company could not afford new equipment because the city insisted on maintaining a five-cent fare. Therefore, the company found an alternate method of modernizing its fleet. In 1934, Third Avenue embarked on a program to replace all of its street cars with modern equipment in its 65th Street and Third Avenue (Manhattan) shop. In 1936, the company stated that it expected to build 600 cars to replace the old cars by 1941. But the company was able to build only 336 new cars by 1940. At that time, the program came to an abrupt halt because the city forced the company to accept a franchise providing for eventual bus substitution. The car rebuilding program began with a prototype, car 1605, which was described in the previous issue. After checking the car’s performance, management decided to rebuild the single-truck convertibles by cutting each car in half, adding a new center section, and building entirely new platforms at each end. Cost was reduced by salvaging the following parts from cars that were being

1

scrapped: truck frames; trolley poles and bases; seat frames, cushions, and backs; air compressors; line switches; journal boxes; door engines; and brake cylinders. All rebuilt and new cars had Brill 77E trucks, which were purchased second-hand or rebuilt from older trucks in the 65th Street Shop. Brill 39E single-motor trucks removed from scrapped cars were salvaged to construct the equivalent of a 77E truck. Motor axle ends of the 39E side frames were joined by welding and mechanical reinforcement to fabricate a new truck designated as 77T. The 100s, 300s, and 626-685 cars were equipped with four 35-horsepower, 600-volt d.c. motors, most of which were purchased second-hand. These cars had higher acceleration and maximum speed than the older two-motor cars. Windows were rattleproof, non-sticking, and weatherproof, and were equipped with shatterproof glass. Window frames were onepiece welded aluminum alloy. The upper and lower sash were fixed in position, while the middle sash could be raised inside the upper sash. The windows were high enough to allow standees to look out and read street signs without stooping. Before rebuilding began, the single-truck convertibles were taken out of service and replaced by other cars, as shown in the following table: (Continued on page 4)


Turn static files into dynamic content formats.

Create a flipbook
Issuu converts static files into: digital portfolios, online yearbooks, online catalogs, digital photo albums and more. Sign up and create your flipbook.
The ERA Bulletin 2012-02 by ERA - Issuu