Manual: Memory Master (optional hand set) (not included / must be ordered seperatly)
UP
UP DOWN
DOWN MEMORY KEY
Startup instruction
The display on your Memory Master shows three zeros and the RESET light is on. Press and hold the down button (any). The frame moves slowly downward. The frame moves downward until it reaches its lowest position. This is now considered a "zero point" or reference point. When the frame reaches its lowest position keep the down button pressed for while until the display shows a number for example: 62 or 63. Your frame is now set and can be moved to any desired height.
Programming a memory position
For comfortable use the hand set has 4 memory positions. Adjust the frame to a favored height. Press the Memory Key it will shows “S –“ To program this height press and hold a number button (“1, 2, 3 or 4”) for about 3 seconds. Every time you press and hold this number button it will adjust the frame to the programmed height.
System restart / RESET MODE To restart the control unit and initiate the reset mode disconnect the control unit from power. You must follow the startup instructions described above to complete the reset mode.
Adjusting the displayed height This function only changes the height position displayed it will not change the height of the frame.
After pressing the memory key the display will show "S". Hold the "DOWN" button for about 6 seconds. The display should be blinking. The height indication displayed can now be changed by pressing the up button or down button. Press "S" again to save and complete the process.
Every time the power is cut off you need to follow the startup instruction. As long as the RESET MODE is not completed you can´t use the height adjustment normally.