3 minute read

Wine glass charms

Next Article
Food news

Food news

Bar carts are this season’s must-have accessory and will add a touch of glitz and glamour to your New Year’s Eve celebrations. They’re lots of fun to revamp, so try your hand at making your own from an old trolley or side table. Yo u w i l l n e e d

z Old side table with wheels z Pencil z Tape measure z Saw z Sanding block z 4 x 97.8cm lengths of Louli scalloped edge moulding, £13.50 each, Camilla Hampton Interiors z Grab adhesive z Panel pins z Hammer z Artisan Gold Bright Effect spray paint, £11.30 for 400ml, Craig & Rose z D-C Fix Reflective gloss mirrored-effect self-adhesive film, £10 for 1.5m x 45cm, B&Q z Craft knife z Old credit card or small squeegee z 5 x WATT T-bar handles, £17.95 each, Plank Hardware z Screwdriver

Advertisement

1Sand the surface of the table to remove old varnish and to give a key to the surface. Wipe away dust and debris with warm soapy water. Leave to dry thoroughly. 2 Using a pencil and tape measure, measure the length of each side of the table’s lower shelf. Mark each side inconspicuously in pencil from 1 to 4. Measure and cut four lengths of scalloped trim to the length of the four side measurements and mark them with the corresponding side number. Vintage tables can vary in size by millimetres on each side, so by numbering the lengths of trim you won’t mix them up and will ensure they fit their corresponding sides perfectly. Attach each length of trim to the sides of the lower shelf using grab adhesive. Hammer a panel pin in at each end to ensure a tight adhesion. Leave for a couple of hours to allow the glue to dry thoroughly.

3Working in a well-ventilated area, ideally outside, give the table at least four coats of paint all over. Pay attention to areas such as the inside of the legs to ensure they are as evenly coated as the outer, more visible surfaces. Work in slow, even strokes to avoid runs or drips and allow the paint to dry thoroughly between each coat. 4 Once the paint is dry, measure and cut a piece of mirror film to fit on the top surface of the table. Peel away the white paper film to reveal the sticky surface, while smoothing the film into position using your other hand. Gently glide an old credit card over the surface to remove air bubbles. Leave the protective top on the mirror film.

5Measure up for the side bars. Place the bar handles on each side of the top surface of the table. Use a pencil and tape measure to mark where you need to drill holes for the screws to affix the handles. Using the correct size drill bit, drill the holes through the tabletop. Working from the underside of the tabletop, attach the screws to the bar handles.

6Measure for the side handle. Place the remaining bar handle on the side of the table, below the tabletop. Use a pencil and tape measure to mark where you need to drill holes for the screws to go in. Drill the holes through the side of the table and attach the screws to the bar handle. Remove the protective top film to finish.

Before

2 3

4 5 6

This article is from: