RCF ZX8060 + TS 9918

MATRIX MIXERS INSTALLED SOUND AX 8042 AUTOMIXER ZX 8060 ZONER

ENG

2013

In fact, dedicated TS 9918 touch sensitive flat remote controls can be used as simple control for devices in several projects, or as additional local controls in larger installations, where a networked centralized control system is required.

RCF RDNet facility offer also a very simple and detailed real-time accessibility and monitoring for any of the enabled product throughout the whole installation: in fact a slot on rear panel allows the integration of an RCF RDNet module into the mixer, so to get control facility through RDNet networking devices too.

Up to 12 paging microphones model BM 3003 can be daisy-chained to the dedicated RJ 45 connector, which can be used in alternative to input 1.

Each of the 3 buttons can be configured to page zones or groups of zones. The consoles are interlocked on the same audio line and report in-use and busy indications.

One relay GPO can be set to report in fail-safe mode the Fault unit monitoring, supported by a watchdog system.

The front panel integrates several LED indicators to give feedbacks on audio inputs and outputs activities, serial communication ports link and GPI-GPO enabling, useful for configuration tests and debugging.

The AX 8042 and ZX 8060 are a 19” 1U rack mounting device and employs a universal 50W power supply, 100-240VAC, 50/60Hz.

Courtrooms

Hotels

Entertainment

INPUTS

OUTPUTS

AX 8042 has 8 universal MIC-LINE inputs with selectable 48V phantom power on detachable Euroblock connectors, 4 of which are also pre-sent on RCA plugs.

AX 8042 has 6 outputs - 4 are balanced on detachable Euroblock terminals and are included in the audio matrix; the 2 remaining are available as RCA plugs.

Great flexibility thanks to its unique design approach 40-bit floating point processing DSP and 48 kHz 24-bit HI-Q Analogue/Digital Conversion, dynamic range > 112 dB 8 universal inputs with 48V phantom facility and full audio processing, 4 hi-level routable outputs with full audio processing + 2 linkable outputs 10 programmable logic inputs (GPI) and 6 programmable logic outputs (GPO), 2 of which supported by relay Two AX 8042 units are linkable to get a 16 input – 12 output solution Configurable parametric EQs, gates, compressors, limiters, delays, priority levels, automatic gain control, levels, gains on in-out and cross points Configurable ALC (Automatic Level Control) facility by using Input 8 to connect a noise detection microphone. The control is then assignable to any output or group of outputs.

USB connectivity for device configuration Serial port for third-party system interface or dedicated RCF configurable touch remote control Pluggable control module implementation AC RDNet IN/OU PLUG for RDNet Networking control Fault monitoring feedback can be set on fail-safe GPO relay 24V DC auxiliary output available for third party utility commands

SPECIFICATIONS

AX 8042

Sampling Rate: A/D-D/A Converters: Max. Input Level: Max. Gain: Max. Output Level: Output Impedance: THD + N (1KHz @ +22dBu): CMRR (1KHz @ Gain:+50dB): CrossTalk: EIN (Gain: +50dB, 150Ohm term): Freq.Response: Dynamic Range: S/N Aweighted: AC Power: Phantom Power:

48KHz 24bit Mic/line +24dBu Bal Mic to Output +50dB max. +24 dBu Balanced 50 Ohm Analog In to Analog Out <0.01% >75 dB < -90dB -122dBm unweighted 20Hz - 20KHz, ±0.5dB >114 dB >90dB 100-240 VAC, 50/60Hz +48V

RISTO-PUB MUSIC PROGRAM MD 7800

PC

DIGITAL LINK RD-NET LINK

ZX 8060

WIRELESS MIC. TX 4016

stereo

stereo

MUSIC PROGRAM

EMERG. SYS PRIOR. INPUT

BM 3003 BM 3003 3 Zone Paging Microphones

RD-NET LINK

ZX 8060

AMP

GENERAL FAULT OUTPUT

Public Areas 100V MONO

TS 9918

AMP

GPI/O interface from/to other systems 3rd parties ctrl system serial interface

AMP

Outdoor Area STEREO

TS 9918

POWERED SPEAKERS

Main Environment STEREO

POWERED SUBWOOFERS

MEETING ROOM DVR

stereo

stereo

MD 7800

MD 7800

MUSIC PROGRAM

MD 7800

PC

WIRELESS MIC. TX 4016

AX 8042 RD-NET LINK GENERAL FAULT OUTPUT

AMP

TS 9918

C3110

TS 9918

C3110 03/2013-SM

3rd parties ctrl system serial interface

POWERED SUBWOOFERS

10409138

GPI/O interface from/to other systems