5. ASSEMBLY AND DISASSEMBLY 5-1. TOOLS FOR DISASSEMBLY AND ASSEMBLY
NO.
TOOL 10mm 13mm 19mm
1
Box driver
2
Double-ended spanner
10, 13,19mm
3
Vice pliers
4
Other(Driver, Nipper, Long nose)
5
JIG for the Tub
Motor (1), Balance (5), 2 holes of each left and right of the shock absorber 1 Pulley hole Replaceable for the box driver. Since the bolt runs idle when the box driver is used, use the box driver 17mm. Tool to protect the idle and abrasion of the bolt for the box driver. General tools for the after service. 1 (Disassemble and Assemble)
21
CLICK HERE TO
DOWNLOAD THE COMPLETE MANUAL
• Thank you very much for reading the preview of the manual. • You can download the complete manual from: www.heydownloads.com by clicking the link below
• Please note: If there is no response to CLICKING the link, please download this PDF first and then click on it.
CLICK HERE TO
DOWNLOAD THE COMPLETE MANUAL
5-2. ASSEMBLY AND DISASSEMBLY Warning! To avoid risk of electrical shock, personal injury or death, disconnect the power to the washing machine Part Name
Descriptive Picture
How To Do
ASS’Y-
ķ Remove the two screws holding the
COVER TOP
Top Cover at the back of the unit.
ĸ Remove the top-cover through push ing and pulling.
Ĺ Then, the Water (Pressure) Sensor, Noise Filter and Water Valve can be replaced.
sensor pressure
water valve noise filter
22
Part Name
Descriptive Picture
How To Do
FRAME ķ Remove the Top Cover and the Ass’y
FRONT
Drawer.
ĸ Remove the two screws on the front of the control panel.
Ĺ Remove the two screws on the plate(u).
ĺ Remove the control panel by disconnect ing the connector that connects PCB to the wire-harness.
23
Part Nam e
Descript ive Pic ture
HowTo Do
FRAME
¤º Insert a flat head screwdriver into the gap and
FRONT
pry down the Cover Front (Left) to separate it.
¤ Remove the Wire Diaphragm from the Frame
Front and unseat the Diaphragm.
¤ Remove the 7 screws on the frame front.
24
Part Name
Descript ive Picture
How To Do
Before removing the belt, should be opened
BELT
the Cover Bottom.
¤ Remove the belt before the re-assembly. ¤Ł Ensure the belt is placed on the center of
¤
the motor pulley. <Belt Assembly> Hang the belt on the motor pulley(¤ ) before placing it around the pulley (¤Ł)
¤Ł
MO TOR ¤ Remove the wire housing from the motor. ¤Ł Remove the bolts holding the motor by using
the power screwdriver. ¤Ø Remove the motor.
25
CLICK HERE TO
DOWNLOAD THE COMPLETE MANUAL
• Thank you very much for reading the preview of the manual. • You can download the complete manual from: www.heydownloads.com by clicking the link below
• Please note: If there is no response to CLICKING the link, please download this PDF first and then click on it.
CLICK HERE TO
DOWNLOAD THE COMPLETE MANUAL