Trouble Shooting

Do Not

• Tow this machine on a slope greater than 12deg. • Operate the X-Floor or the Bed Storage Floor in the backward direction with material in the machine. • Travel with the elevator down/out unless feeding out at very slow speeds’ • Actuate the control levers backward and forwards to ‘free’ the load if the floor or elevator chains become jammed. As this can cause damage to drives and hydraulics. • Overload the machine with material. • Use the elevator in the traveling position to feed out. Always extend the elevator out to feed. Note if the bed storage chain fails to move, extend the elevator fully so the rear flaps are out of the machine then retract into feeding position. • Ride on any part of the machine while traveling • Water blast the load cell head unit, load cells or junction box. • Apply excessive material pressure on to elevator with Cross-Floor load. • Weld on the machine with a load cells fitted. • Leave strings in machine during or after operation.

General Issue

ISSUE POSSIBLE CAUSE SOLUTION

Elevator won’t tilt • Hydraulic Hoses not plugged into tractor correctly • jammed Elevator • Bent Ram • Oil flow from tractor too low • Clean and plug into tractor correctly • Check for foreign objects in elevator body • Increase oil flow to 50-80 Litres • Replace Ram

Elevator won’t start • Hydraulic Hoses not plugged into tractor correctly • jammed Chains • Oil flow from tractor too low • Clean and plug into tractor correctly • Check for foreign objects in elevator chains • Increase oil flow to 50-80 Litres

Elevator works but Cross Floor won’t go in one or either direction • No power at electric controller • jammed Chains • Damaged wiring • Defective Coil on valve

Tail Gate opens unexpectedly

Cross floor won’t stop • Broken catch latch spring • Latch spring tension to lose

• Feed controller switch in (silage mode) • Check power fuse, power at controller • Check for foreign objects in Cross

Floor chains • Check Controller plugged into machine • Check electrical cabling for damage • Replace Coil

• Replace the Latch spring • Tighten Latch spring tension

• Switch to bale mode

Elevator stall

Feed Controller does not work

Joystick Controller does not work

Weighing system Not Working • Oil flow, pressure from tractor too low • Cross floor speed set to high • Pause button presses

• Not plugged into wagon • Damaged wiring • No power

• Not plugged into wagon • Damaged wiring • No power

• Battery flat • Out of range • Device not connected • Increase oil from tractor • Adjust feed control to slow cross floor • Release pause button

• Plug it in • Check wiring • Check power supply

• Plug it inl • Check wiring • Check power supply

• Check battery voltage, should be 3.6V replace if voltage low. • •Move closer and try again • Check settings and re connect, also check • 31uetooth in turned on in device

COMBI CM116/CM156 FEEDOUT WAGON

Hustler Equipment LTD PO Box 2127, 1416 Omahu Road Hastings, 4153, New Zealand. Phone +64 6 879 7926 www.hustlerequipment.co.nz