OPERATIONS AND MAINTENANCE

All activities connected with the fork servicing can be done by the operator of the vehicle to which the fork is attached, provided that he is authorised to operate the vehicle. The fork servicing is only possible after reading the Instruction Manual.

All service and maintenance works should be done with the vehicle engine stopped, released pressures and zeroed revolutions, with active vehicle and machine protections.

After work servicing

Each time, after finishing work, the fork should be cleaned and placed on flat hardened surface. Then you should make an inspection of connections of parts and assemblies. Worn or damaged parts should be immediately replaced by new or regenerated ones. You should check all screw connections and tighten the loosen ones in accordance with the table 3 of screws and nuts tightening torque values. All safety signs placed on the fork, triangle plate distinguishing slow-moving vehicles should be kept clean.

Table no.3 the screws and nuts tightening torque values

After Season Maintenance

Includes all operation steps listed in paragraph entitled: After work servicing. Additionally, the fork should be stored under canopy on flat hardened surface. It is recommended to place wooden blocks under the fork. You should make sure that paint cover is tight. If there is no paint in some places you should clean up the areas and apply new protection coating layer on them.