already too far aft
Cut slot for vertica
ertical tail
Aft Fuselage Top (make 1)
Inboard inlet sides (make 2 from 3mm Depron)
Wing (make 1)
Note: Inside of canopy can be hollowed out if airplane CG is not already too far aft
Fwd fuselage top outside (make 1)
(make 1)
Turtledeck Top (make 1)
Canopy (make 12 with 6 mm Depron (14 if BlueCore) and be laminate together) s not
Nosecone to (trace outline o to assist in ca
Inlet spacer (make 2 from 3 mm Depron)
Missle rails (make
Vertical tail ra (make 2 from 3
make 2 from 1/4" x 5/16" balsa)
tail radar fairing from 3mm Depron)
Fwd Fu
one top view template utline on top of nosecone st in carving it to shape)
Vertical Tail (make 1)
4
2
Sc 0
(make 1 from 1/32" mus
Scale in inches 2
4
Elevon and rudder control horns " music wire) (make 3 from 1/32" plywood)
(ma
Bulkhead F-2 (make 1)
lage ide 1)
Bulkhead F-1 (make 1)
Fwd fuselage top inside (make 1)
Aft wing fairing (make 2)
(make 12 (14 if B lamin
Fuselage top spine (make 2 and laminate)
Nosecone ke 12 with 6 mm Depron 14 if BlueCore) and laminate together)
d Fuselage Bottom (make 1)
ring
5/8" foam tria ngle
Canard (make 2)
Turtledeck Sides (make 2)
4
3/4" square 1/64" ply doublers on inboard side (drill 3/16" hole for pivot bearing tubes)
Template for rudder pus (make 1 from 1/32" mus
er pushrod endElevon and rudder control horns " music wire) (make 3 from 1/32" plywood)
1/2" wide foam strip
Aft Fuselage Bottom (make 1)
Fwd Fuselage Sides (make 2) F-1 3/8" balsa triangle
F-2
F-2
3/4" square 1/64" ply
Motor mount (make 1)
Servo tray (make 1) 1/2" wide foam strip
Co
Designed by Steve Shumate Copyright Š 2004
All Rights Reserved