EDU2AE/TOP/E & UPGRADED EDU2AE/TOP/TA The EDU2AE/TOP/E (code 031000/TOP/E) and the improved version of our EDU2AE/TOP/TA (code 031000/TOP/TA) implement our existing controllers with the following features:
- Saving/programming on USB flash drive (front panel): you can now save the results of each screwing operation directly on USB pen drive! It is also possible to upload via USB drive all parameters/programs previously set on “EDU EXPAND”. Just connect your USB to the port and recall the desired programs on the menu. The programs set on control unit can be downloaded on USB and recalled on another unit and on EDU EXPAND, too. - The control unit is supplied standard with EDU EXPAND software and an 8Gb USB flash drive.
CONTROL UNIT
USB Flash Drive
EDU EXPAND Software
EDU2AE/FR & EDU2AE/HPRO
EDU2AE/FR (code 031000/FR) is intended for use with PLUTO..FR: - Run time, to set the tightening time. - Screw count - Cycle end, motor on, reset, missing piece signals - Serial port - Screwdriver connector as an option on the back panel.
EDU2AE/HPro (code 031000/HPRO) adds to the EDU2AE/HP: - Cycle end, motor on, reset, missing piece signals - Serial port - Screwdriver connector as an option on the back panel.
36016 THIENE - ITALY - Via Marco Corner, 19 - Tel. +39 0445 371068 - Fax +39 0445 371069 - kolver@kolver.it - www.kolver.it - www.kolver.com
UPDATE 2014
- PC programming (back panel): it is possible to set, change and save all parameters through our new “EDU EXPAND” software for PC. EDU EXPAND communicates with the control unit via miniUSB or RS232.