Vehicle Access Solutions for Perimeter Protection
MRS Rising Step »» The MRS series of Rising Step Barriers are designed to prevent unauthorised vehicles from crashing through controlled entry and exit points. »» Built for fast reliable and efficient operation, these barriers are capable of withstanding high impact loads and are ideally suited for installation where site security is paramount. »» Typically installed in high security environments such as correctional facilities and government/military/law enforcement buildings.
Construction The frame and structure of the Rising Barrier is fabricated from heavy guage steel fully welded prior to hot dip galvanising which ensures maximum protection against corrosion. The barrier is hinged on its full length by a continuous stainless steel bar of 76mm diameter. The impact face of the barrier is reinforced with steel ribs and impact plates to transfer mechanical forces to the required load surfaces and the suitably reinforced concrete foundation. The top cover is made of galvanised steel checker plate.
MRS,001_EN_01/06.2015 | Subject to change without prior written notice.
Controller The programmable logic controller (PLC) is provided with an EPROM chip to enable software adaptation and interfacing with a variety of remote control devices, security access systems and key card readers. It also integrates the inputs from limit switches and safety control devices. Outputs are available for the motor driver, directional solenoids, status conditions and warning lights. Control voltage is 24v DC and the controller is housed in a lockable IP65 rated steel enclosure which needs to be located in a secure environment. Safety A safety valve locks the barrier in the “up” (secure) position in case of hydraulic failure or sabotage. A Manual hand pump is available. Accessories including traffic signals, safety beams or loop detectors are recommended and may be provided to suit specific applications.
Technology The barrier is operated from 2 parallel high speed hydraulic cylinders. A power pack containing an electric motor-pump assembly and an accumulator is installed adjacent to the barrier in a lockable enclosure. Limit switches provide feed back for the fully up or fully down position of the barrier. Hydraulic energy stored in the accumulator during the rest period powers the step up in the shortest possible time.
www.ac-magnetic.com/australia
Technical Data
Type
MRS600
MRS1000
Height (above roadway)
mm
600
1000
Standard Width
mm
3500
3500
Pit Size (W x D x H)
mm
3620 x 1213 x 820
3652 x 1826 x 1354
Opening Time
sec
2.5
3.0
Voltage
V
415 - 3 Phase
415 - 3 Phase
Frequency
Hz
50
50
Power
Kw
15
15
Duty Cycle
%
100
100
Kmh/T
30/10
64/7.5 PAS68 Level
Bar
200
200
Tonne
10
10
Year
1
1
(other sizes available upon request)
Impact Strength Operating Pressure Axle Loading Warranty
MRS,001_EN_01/06.2015 | Subject to change without prior written notice.
Diagram provided for information purposes only
National Sales & Service 1300 364 864
Example Installations
Melbourne Head Office +61 3 9339 2900 info@magnetic-oz.com
Sydney +61 2 9421 8800 nswsales@magnetic-oz.com
Brisbane +61 7 3801 2100 qldsales@magnetic-oz.com
Perth +61 8 9205 9900 wasales@magnetic-oz.com
www.ac-magnetic.com/australia