Addressable Flashing Beacon I-9314 Technical Specifications • • • • • • • • • • •
Operating voltage: 24Vdc nonpolarized, Loop powered Operating Current: Standby current .8mA Action current 16mA Operating temperature: -10°C to +50°C Loop capacity: 10 pcs. p/loop Relative humidity: 95% Flashing Average:20-80times p/min Application: Indoor use Material and colour: ABS,ivorywhite; Plexiglas / red Mounting Type: wall mounting Wiring: 1 pair polarized Dimensions: 120mm×80mm×49mm
Features and Benefits 1. 2. 3. 4. 5. 6.
Loop powered beacon Can be programmed to any single or group of devices High intensity flashing LED Wall mounted Electronically addressed Easy installation and connection.
Description I-9314 Addressable Flashing Beacon or Door Lamp is used to display the alarms of indoor detectors. It can be installed on sites easy to view, such as on top of the door of meeting room, dining room and bedroom. When the indoor detector alarms, the LED on the lamp will flash so that personnel may know the detector has triggered alarm without entering the room. Electronic addressing can be done through Handheld Programming device (P-9910), purchased separately.
Beacon Installation The flashing beacon should be installed in compliance with all local codes and/or NFPA 72 National Fire Alarm Code, NFPA 70 National Electrical Code, BS5389, and EN45. It is installed onto a standard one gang electrical box with a mounting hole that have 6.5cm spacing.
Addressable Flashing Beacon I-9314 Wiring and Connection Connect the wires to the required terminal according to the wiring diagram. The terminal 13 (Z1), 14 (Z2) is for addressable Loop, non-polarized. The cable must be fire rated type and the size depends on the wiring distance. Minimum recommended size gauge is 1.0mm².
Selection of compatible Control Panels Compatible with all GST Fire Alarms Panels GST 200-2, GST 5000, GST IFP8.
Ordering Information: Part No
I-9314 Z1 Z2
LOOP IN
Description
Addressable Flashing Beacon
Weight /Kg
.166
Pack Qty per Box 100
LOOP OUT
Programming The address and setting of the flashing beacon can be programmed using GST handhold programmer (P-9910), purchased separately. Connect the two wires of the handheld programmer to terminals 13 and 14 of the device. See Addressable Flashing Beacon manual for more programming information.
1 2 3
4
5
6
7
8
16 15 14 13 12 11 10 9
Z1 (14) AND Z2 (15) TERMINAL
FIELD DEVICE PROGRAMMER
MANUFACTURED IN ACCORDANCE WITH
Note: Specifications are subject to change without notice.