L121
Screws
Installation without removing LED rail
1
Unscrew end caps and remove.
2
Slide lens to one side then pull out.
3
Attach rail to a wall support with mounting screws (not supplied) on both sides of rail.
End Cap
CAUTION
Rail Extrusion
• Read all instructions. • WARNING: RISK OF FIRE OR ELECTRICAL SHOCK: Do not make or alter any openings in the compartment of wiring or electrical components during installation. Do not alter or add ballasts, or any other electrical components. • Installation and use of this fixture mounting assembly requires a person familiar with the construction and operation of luminaire electrical systems and the hazards involved, if not qualified, do not attempt installation.
Connect fixture wires to low voltage wiring (remote LED driver).
• Turn off power before installation.
5
Insert lens and attached end caps to rail.
6
Install drywall under the lip of the rail extrusion so the face of L121 is exposed.
Lens
• Do not spray water on fixture during cleaning. Avoid using detergents with hand softeners, anti-bacterial agents, glass cleaners or acrylic cleaning products. • KEEP THESE INSTALLATION INSTRUCTIONS.
Support
Parts
Qty.
• Rail • End Caps • Lens • Hex countersunk tapping screws
1 2 1 4
Tools • Drill • Hex driver
not included not included
Maintenance Clean using a soft cloth.
T 604 708 1184 mplighting.com
Mounting Screws
Copyright © MP Lighting All technical information in this document is subject to change.
4
Installation Instructions
Version 07-2010
Unscrew end caps and remove.
2
Slide lens to one side then pull out.
3
Remove LED rail inside extrusion by unsnapping and pulling out.
4
Connect fixture wires to low voltage wiring (remote LED driver).
6
Push LED rail into extrusion until it clicks into position. Insert lens and attached end caps to rail. Install drywall under the lip of the rail extrusion so the face of L121 is exposed.
Installation Instructions
End Cap
CAUTION
Rail Extrusion
• Read all instructions. • WARNING: RISK OF FIRE OR ELECTRICAL SHOCK: Do not make or alter any openings in the compartment of wiring or electrical components during installation. Do not alter or add ballasts, or any other electrical components.
Attach rail to a wall support with mounting screws (not supplied) on both sides of rail.
5
7
L121
Screws
• Installation and use of this fixture mounting assembly requires a person familiar with the construction and operation of luminaire electrical systems and the hazards involved, if not qualified, do not attempt installation. • Turn off power before installation.
Lens
• Do not spray water on fixture during cleaning. Avoid using detergents with hand softeners, anti-bacterial agents, glass cleaners or acrylic cleaning products. • KEEP THESE INSTALLATION INSTRUCTIONS.
Support
Mounting Screws
Parts
Qty.
• Rail • End Caps • Lens • Hex countersunk tapping screws
1 2 1 4
Tools • Drill • Hex driver
not included not included
Maintenance Clean using a soft cloth.
T 604 708 1184 mplighting.com
LED Rail
Copyright © MP Lighting All technical information in this document is subject to change.
1
Version 07-2010