1
Drill holes and mount rail to wall.
2
Insert wire leads and arm module.
3
Turn arm module 90° and lock setscrew with Allen key.
4 5 6
L181
Installation Instructions
Rail
Rail Cover
Screws
Trim rail cover to appropriate size and fit into place.
Bars Setscrew & Cover
Install bars for holding wine bottle. Connect fixture wires to low voltage wiring (remote LED driver 350mA constant current).
Wire Leads
Parts
Qty.
• Rail • LED arm module • Bars • Cross countersunk screws • Wire connectors • Rail cover • Setscrew & cover
1 1 2 4 2 1 1
Tools • Phillips screwdriver • Allen key • Utility knife
not included included not included
Maintenance Clean using a soft cloth.
• Read all instructions. CAUTION
• WARNING: RISK OF FIRE OR ELECTRICAL SHOCK: Do not make or alter any openings in the compartment of wiring or electrical components during installation. Do not alter or add ballasts, or any other electrical components. • Installation and use of this fixture mounting assembly requires a person familiar with the construction and operation of luminaire electrical systems and the hazards involved, if not qualified, do not attempt installation. • Turn off power before installation. • Connect to 350mA appropriate constant current LED driver only. • Do not over tighten screws. • Do not spray water on fixture during cleaning. Avoid using detergents with hand softeners, anti-bacterial agents, glass cleaners or acrylic cleaning products. • KEEP THESE INSTALLATION INSTRUCTIONS.
T 604 708 1184 mplighting.com
Copyright © MP Lighting All technical information in this document is subject to change.
LED Arm Module
Version 07-2009