10mm 3/8” minimum depth
1
m 5m Ø3 -3/8” Ø1
Drill a Ø1-3/8” (32mm) hole.
LED52 Installation Instructions
CAUTION • Read all instructions.
2
Connect fixture wires to low voltage wiring (remote LED driver 350mA constant current).
3
Screw LED housing to shelf, cabinetry or millwork.
4
LED Housing
• WARNING: RISK OF FIRE OR ELECTRICAL SHOCK: Do not make or alter any openings in the compartment of wiring or electrical components during installation. Do not alter or add ballasts, or any other electrical components. • Installation and use of this fixture mounting assembly requires a person familiar with the construction and operation of luminaire electrical systems and the hazards involved, if not qualified, do not attempt installation.
Thread cover into LED housing. Use a tool in cover holes to help tighten.
Cover
• Turn off power before installation. • 350mA constant current driver only. • Do not spray water on fixture during cleaning. Avoid using detergents with hand softeners, anti-bacterial agents, glass cleaners or acrylic cleaning products.
41mm 1-5/8”
10mm 3/8” 41mm 1-5/8”
Parts
Qty.
• LED unit • Cross countersunk screws
1 2
Tools • Phillips screwdriver • Snap ring pliers
not included not included
Maintenance Clean using a soft cloth.
T 604 708 1184 mplighting.com
10mm 3/8”
Copyright © MP Lighting All technical information in this document is subject to change.
• KEEP THESE INSTALLATION INSTRUCTIONS.
Version 07-2009