/P-C3_inst

Page 1

Mount C3 Canopy and Pendant

1

Unbraid outer woven wire to expose 1/2” (13mm) of inner wire. Twist outer strands tightly together.

2

Strip 1/8” (3mm) of insulation from inner wire.

3

Connect braided coax wire to 60W minimum 12V transformer. Next, connect primary to driver input wires then fit into electrical box.

4 5

INPUT PRIMARY 120/277V 12V Transformer 92mm 3-5/8”

92mm 3-5/8”

C3 Canopy Ceiling Mount Pendant

Installation Instructions

CAUTION • Read all instructions. • Risk of fire and electrical shock. Turn off power before installation. • Do not over tighten screws.

For remote driver connect fixture wires to low voltage wiring.

• Connect to 12V electronic transformer.

Align canopy to electrical box. If necessary mount universal crossbar to electrical box then mount canopy to crossbar.

• Maximum 50W lamp.

Tighten screws with Allen Key.

• Test installation by leaving fixture on for 20-30 minutes to ensure proper operation. • Keep this document as a reference.

3mm 1/8” Copyright © MP Lighting All technical information in this document is subject to change.

13mm 1/2”

• Use only low voltage electronic dimmers.

T 604 708 1184 mplighting.com

Version 05-2008


Adjust Pendant Length on C3 Canopy

1 2 3

Cut coax wire to desired length. Unbraid outer woven wire to expose 1/2” (13mm) of inner wire. Twist outer strands tightly together. Strip 1/8” (3mm) of insulation from inner wire.

5

Place strain relief in center hole and pull wire through canopy.

6

Tighten setscrew when pendant is adjusted to desired height.

C3 Pendant

Pendant Length Adjustment Instructions

CAUTION • Read all instructions. • Ensure setscrews are tight and firmly holding wire to prevent pendant from falling. • Keep this document as a reference. • Make sure strain relief is positioned properly with open side facing away from setscrew. Failure to do so may cause setscrew to pierce cable and short pendant.

Copyright © MP Lighting All technical information in this document is subject to change.

4

Remove setscrew on canopy.

13mm 3mm 1/2” 1/8”

T 604 708 1184 mplighting.com

Version 05-2008


Turn static files into dynamic content formats.

Create a flipbook
Issuu converts static files into: digital portfolios, online yearbooks, online catalogs, digital photo albums and more. Sign up and create your flipbook.