Quality Electric Underfloor Heating
INSTALLATION GUIDE
Laying the Cable Kit 1 Install thermostat sensor cable and conduit for cold tail connections. Clean the substrate and lay your chosen insulation boards as shown on page 3.
2 Work out the cable spacing using the calculation on page 5 of this guide. IMPORTANT: Minimum spacing 5cm Measure and mark spacing onto the floor or insulation boards.
3
Lay the cable in parallel runs across the heated area of your floor, taking care to observe the minimum cable spacing of 5cm. Fix firmly in position using the adhesive tape.
4
Cover the entire heating system in a 10mm layer of flexible self levelling compound, or tile directly over the cable using a flexible tile adhesive. Use a full bed of adhesive to ensure cable is completely covered.
6
www.comfortzone.co
info@comfortzone.co
E&OE
