SATURN LED RECTANGULAR HIGHBAY INSTRUCTIONS
Issue 01 on 6th March 2024
THANK YOU for buying this product. To help ensure itgives complete satisfaction please install it according to these instructions and then pass theinstructions to the appropriate person for retention and futurereference.
SAFETY This is a mains powered product. It is designed to be installed by suitably qualified personnel only and in accordance with the applicable building and electricalregulations. Before installation or maintenance the electrical supply to the product must be isolated.
INSTALLATION SUPPORT If installation advice or accessories are required please also contactus at the above address. We will do ourbest to help. When reporting asuspected fault or seeking installation support the problem is likely to be resolvedmostquicklyif you have fullproductdetails to-hand,as wellas details of when andwhere it was purchased.
LUMINAIRE INSTALLATION
1. For Suspended mounting: the fitting is supplied complete with the suspension brackets, ensure the chosen method is sufficient to support the luminaireweight. See diagram above for hooking / fixing points.
2. For Surface Mounting: use the surface mount brackets supplied separately, ensure the chosen method is sufficient to support the luminaireweight. (Part code:NSA/SURF-MNT/BRKTS) see diagram above for fixing points.
• Use the 4 allen keyhead screws provided to fix the brackets in place.
3. The fitting comes with multi-cct & wattage selection: default settings are 4000K &200W. This can be changed using the slider switches on top of the fitting (see table below)
4. The luminaire is supplied with a power supply lead already attached. Route the free end toa suitable connection point & terminateensuring correct polarity isobserved.
WARNING: THIS LUMINAIRE MUST BE EARTHED
5. Reconnect power supply & check for correctoperation.
Optional HR Lens Pack
1. Optional HR Lens Pack is available forhigh rack applications where anarrow aisle distribution is needed.
Part code – NSA/HR/LENS/PACK, supplied separately.
2. To swop the lens:
Remove the existing 90º Lens by undoing the screws, beingcareful not tolose any of the screws.
Replace using the HRlens and do the opposite of above.
MAINTENANCE
The luminaire should be switched off & allowed to cool before any maintenance is carried out.
1. Cleaning of the glass front cover should be carried out at regular intervals so as not impairphotometric performance.
2. Dust should not be allowed to accumulateon the rear of the product as this will affect the thermal performance of the heat sink.
