FOUR TYPES OF INJECTION MOLDING MACHINES Injection molding is a processing technique for converting thermoplastics or thermosetting materials into variety of types of products. An injection machine or injector can be classified four units: plasticizing and injection units, clamping and opening unit, ejecting or knockout unit, and electric and hydraulic control system.
There are four basic types of injection molding equipment in use today according to the type of screw or plunger. In the following paper, we will introduce you these four types of injection molding machines.
Conventional injection molding machine
In this process, the plastic granules or pellets are poured into a hopper and feed into the chamber of the heating cylinder. A plunger then compresses the material, forcing it through progressively hotter zones of the heating cylinder, where it is spread thin by a torpedo. The torpedo is installed in the center of the cylinder in order to accelerate the heating of the center of the plastic mass. The torpedo may also be heated so that the plastic is heated from the inside as well as from the outside.
The material flows from the heating cylinder through a nozzle into the mold. The nozzle seals the cylinder and the mold, and prevents leaking of molten material. The mold is held shut by the clamp end of the machine. For polystyrene, two of three tons of pressure is generally used for each inch of projected area of the workpiece and runner system.
Piston-type preplastifying machine
This machine employs a torpedo ram heater to preplastify the plastic granules. After the melt stage, the fluid plastic is pushed into a holding chamber until it is ready to be forced into the mold. This type of machine produces workpiece faster than a conventional machine, because the molding chamber is filled to shot capacity during the cooling time of the workpiece. Due to the fact that the injection plunger is acting on fluid material, no pressure loss is encountered in compacting the granules. This allow for larger workpiece with more projected area.
Screw-type preplastifying machine
It is an extruder used for plasticizing the plastic material. The turning screw feeds the pellets forward to the heated interior surface of the extruder barrel. The molten, plasticized material moves from the extruder into a holding chamber, and from there is forced into the mold or die by the injection plunger. The use of