Manual

Portable Charger, Super Capacity Battery Pack

Powerlink “LUKAS” i5200 U ser guide

www.inetbill.co.kr Copyrightⓒ 2010 inetBill corp. All rights reserved.

Portable Charger & Super Capacity Battery Pack

powerlink i5200 User Guide

2

Portable Charger & Super Capacity Battery Pack

Powerlink

• Samsung SDI Li-ion Rechargeable battery

i5200

User guide

With large capacity Lithium-ion battery (5,200 mAh), your mobile phone (700 mAh) can be charged about 4 or 5 times.

• Protection Multiple protection is provided by both hardware and software method for safety issues such as overvoltage, over-discharging, over-charging, overheating and excessive output (load) current etc.

• Automatic circuit disconnection When none of the device to be charged is connected to powerlink, automatic disconnection circuit is activated and unnecessary electrical discharge is avoided.

• USB output Any devices that can be charged through PC's USB port are able to be charged using Mobile Station.

Introduction Up to now, the users of mobile phone or many mobile devices have felt inconveniences from the short operating time due to small battery capacity. To remove this kind of inconvenience, this battery charger is born. This Lithium-ion battery equipped charger allows to charge mobile devices regardless of place and time. It can also be used as a large capacity battery.

• Battery status Introduction of the proprietary battery management IC, namely Smart Battery IC, allows to count the remaining charge amount precisely, which is revealed on the two full color LED by 5 stages.

• Concurrent charging The powerlink and the device connected to it can be charged simultaneously.

English

3

1.1 Package contents and Features 1.2 Charging Powerlink i5200 2. How to use 2.1 Charging mobile device 2.2 Checking the remaining battery capacity 3. Appendix 3.1 Troubleshooting 3.2 Safety Notes 3.3 Specification

powerlink i5200 User Guide

4

1. Powerlink i5200 overview

Contents 1. Powerlink i5200 overview

Portable Charger & Super Capacity Battery Pack

3

1.1 Package contents and Features

4 5 6

� Standard 4 pin USB connector

�

7 9

�

Powerlink i5200

10 11 12 14

� � Standard TTA 24 pin or mini USB B 4 pin connector

Cable

User guide

• Body of i5200 � DC Output terminal (to be connected to mobile device) � Display for the remaining battery capacity � CHECK Button (to check the remaining battery capacity / to turn on the output) � Charging input connector for the Mobile Station (to be connected to the charger) � Reset hole to reset the i5200

English

5 1.2 Charging Powerlink i5200 To initialize the remaining battery check feature, powerlink must be fully charged before first use.

Plug the charger output into the Mobile Station's charging input connector and then plug the AC cord into the AC outlet or PC’s USB port.

Charging time • i5200B - TTA charger(750 mAh) : 6~7 hours • i5200S - AC adaptor(1 Ah) : 6~7 hours • PC’s USB port(500 mAh) : 9~10 hours

Indication

Portable Charger & Super Capacity Battery Pack

powerlink i5200 User Guide

6

2. How to use 2.1 Charging mobile device Connect the accompanied cable to the DC Output terminal of the powerlink and connect the appropriate gender conversion connector among those provided with the Mobile Station and then, attach the mobile device to be charged. Then press to start charging. * Any devices that can be charged through PC's USB port are able to be charged using powerlink.

Normal operation is available during charging the device such as making or receiving a call * from mobile phone or watching TV from a mobile TV or listening to music from a music player, etc. Sometimes the power conversion noise might interfere RF transmission capability of the mobile device during charging.

Several standard gender converters are accompanied together. Contact our company for dis* cussions about volume production of other kind of gender converter.

• i5200B - TTA chargers indicate • i5200S - Full color LED MP3 Player Mobile phone

[Notes] - Powerlink must be fully charged before first use to initialize the counter for the remaining charge amount.

- Recommand using the accompanied charger or certificated standard charger.

Use of unauthorized charger may lead the device failure.

PMP

Digital camera

Gaming device (PSP, Nintendo)

PDA, Pocket PC

English

7 �Example of uses

Portable Charger & Super Capacity Battery Pack

powerlink i5200 User Guide

8

2.2 Checking the remaining battery capacity Press to display remaining battery capacity.

Equipped with the smart control IC, this product displays the remaining battery capacity

1. Connect the accompanied cable to the DC Output terminal of powerlink.

2. Connect the appropriate gender converter to the other side of the cable. * Check if gender is applicable the device before use.

3. Press to start charging.

4. When the device is fully charged, separate the device from the Mobile Station.

Remaining battery capacity : 20% unit, 5 stages RED - MAGENTA - ORANGE - GREEN - BLUE(full)

English

8

Portable Charger & Super Capacity Battery Pack

powerlink i5200 User Guide

9

3. Appendix 3.1 Troubleshooting • After purchased, Do I have to use the products after full charging?

- Please charge full before using in order to initialize the counter for remaining charge amount. If you don't, the value displayed is incorrect till you fully charge the Powerlink.

• Is it possible to use any matched connectors with Powerlink which are not produced and provided by inetbill?

- Any TTA (one of the Korean Standard Organization) approved or our company provided charger shall be used. We disclaim all responsibility for damages resulting from misusing the charger or using nonrecommended charger.

- Recommand using the accompanied charger or certificated standard charger. Use of unauthorized cahrger may lead the device failure.

• Any restriction on the kind of devices which can be charged?

- Any products which can be attached to the USB port of PC can be charged. It means the Voltage Rating is similar to the USB port of PC.

• I pressed the

, but Powerlink doesn't charge.

- Most plausible cause is the Powerlink in low voltage lockup state. The low voltage lockup state is to protect the battery from the failure by over-discharge. First press the reset button. If no method get out and please contact the designated service center in this situation.

• Why do I have to press

to start charge?

- Powerlink automatically disconnects the output after detecting 5 minutes of no current flowing on the output port to save the battery charge during idle state, which means you need to trigger the output by pressing.

• When I pressed the

, the battery capacity was displayed, but the mobile device connected to the Powerlink doesn't charge.

- Check the cable connection and gender converter.

Please contact the designated service center when you found nothing wrong on the cables and the gender converters.

• If you leave the Powerlink without using for a long time, what happens?

- The Lithium-ion batteries discharge 3~5% per month. If you put the Powerlink without using for a long time, let's say one year, it discharges continuously and reaches to the low voltage lockup state and it can't be charged any more. We recommend you to charge even once every 6 months and put it in the place not so hot, not so cool and evade from direct sunlight which cause heating.

• How long is the life span of Powerlink?

- When you execute the charge-discharge cycle about 300~500 times, the capacity decreases about to 70 percent. After then, it continue to decrease.

- If you use under very high or very low temperatures, Powerlink could be damaged or its life can be shortened.

3.2 Safety Notes � Cautions in use 1. Powerlink must be fully charged before first use.

2.Recommand using the accompanied charger or certificated standard charger .

Use of unauthorized charger may lead the device failure.

English

10 3. When not in use, store it in a normal temperature, not too hot and not too cool. Do not place under the sunlight for a long time. Charge at least once every 6 months.

11 3.3 Specification

4. Do not expose under high temperature such as near the car window under the direct sunlight.

Keep it within 0~40℃ in temperature. (Excessive temperature could deform the product or cause the failure.)

Rated Capacity

Samsung SDI Rechargeable Lithium-Ion (5,200 mAh)

Output Voltage

5.0 V

Output Connector Type

USB A 4 Pin

5. Make sure that the conductive objects such as necklace or coin do not contact the terminal area (metal part) of the product, which may cause the short circuit. (The short circuit could make the product and objects overheat, causing a fire.)

Charging Time

i5200B - TTA charger(750mAh) : 6 ~ 7 hours i5200S - AC adaptor(1Ah) : 6~7 hours PC’s USB port(500mAh) : 9~10 hours

Display of Charging Amount

i5200B - TTA charger / i5200S - Full color LED

6. Do not disassemble or repair the product without permission. Contact the store or customer service center for repair.

Charging Methods

Charger provided

Dimensions

42(W) x 92(L) x 25(H) mm

7. Keep it away from heating sources as it may explode.

Weight

128g

8. Make sure that the product is not wet and do not put it into the water.

Operating Temperature

0 ~ 50 ℃

9. Do not drop or give a strong shock to it. It could be damaged or its life can be shortened.

� Disclaimer 1. The manufacturer, store and distributor do not take any responsibilities from losses or damages which occur due to accident or user's error.

2. The user's manual is completed based on the current specification of the product.

3. The specification and use of the product is subject to change for performance improvement without prior notice.

* May vary depending on use environment and operation Thank you very much for purchasing portable chager and super capacity battery pack, Powerlink i5200.

Please visit our website (www.inetbill.co.kr) for more details and services.

Hanshin IT Tower Room #1207 235 Guro-Dong, Guro-Gu, Seoul Korea (152-768) Phone : (82-2) 867-4228 / Fax : (82-2) 867-4230

Copyrightⓒ 2010 inetBill corp. All rights reserved.

English