Tech Zone Tech Zone h Zone Tech Zone Tech Zone TTech Zone
Tech Zone Tech Zone
Tech Zone Te one
Tech Zone Te
Tech Zone
Te ech Zone
Tech Zone e T ch Zone Tech Zone Tec TTech Tech h Zone Z Tech Zone Tech Zone T ech Zone Tech h Zo one Tech Tech Zone one Tech Zone Tech ech Zone Tec Tech T Zone Tech Zone Tec Tech Zone
Tech Zone
Tech ZZone
Tech Zone
h Zo one e
Tech Zone e
Tech Zone
Tech Zone
Tech Zo one on
Tech Zone Tech Zone
Your Global Media Partner Incorporating
REMANUFACTURING THE
XEROX PHASER
and
magazines
3610 TONER CARTRIDGE
S
P P U
M E L
T N E
2
TECH ZONE
Mike Josiah
$215.00*
106R02722
14,100 pages
$400.00*
106R02731
25,300 pages
$541.00*
step >
5,900 pages
2
Slide the toner port open. Clean out all the remaining toner.
step >
106R02720
1
4
5
Fill with toner for use in the Phaser 3610.
step >
The cartridges used in these machines are as follows:
step >
The Xerox Phaser 3610 series of printers are based on a 47 ppm engine with a maximum resolution of 1200 x 1200 dpi. The first page out is stated to be under 6.5 seconds. The Printers memory is fixed at 512MB. The toner cartridges are just simple tubes. They will be included in a future “Easy to do” cartridge series, but there has been a lot of questions on them so we’re doing it now also. Other machines that use this cartridge are Phaser 3040, WorkCentre 3615 and WorkCentre 3655. As these are so fast and simple to do and with the costs so high for new cartridges, they are nice profit centers!
step >
Remanufacturing the Xerox Phaser 3610 Toner Cartridge
6
Slide the toner port cover back in place. Make sure the tab is
The Non Gear end cap can be removed for cleaning and filling, but it’s difficult and time consuming to do. As you release one side the other locks back in place.
The recommended method is to clean and fill through the toner
port.
*Pricing as of January 2016
Required Supplies • Toner for use in the Xerox Phaser 3610 series • New replacement chip (Check for the proper region)
step >
Required Tools • Toner approved vacuum. • A small Common screw driver
3
Press down on the small tab on the toner port cover.
locked!
LOOKING FOR STEP-BY-STEP GUIDES FOR CARTRIDGES? Mike Josiah's popular toner cartridge procedures are available in hardcopy format in some regions, and online to all regions as a library of cartridge models—sponsored by UniNet Imaging: www.uninetimaging.com Issue71|www.iRecyclingTimes.com
TECH ZONE
3
Press in on the small tab to release the chip. Install the new
10
step >
Slide the holder towards the toner port and remove.
step >
8
9
chip.
step >
step >
7
Press in on the center tab of the chip holder.
step >
Mike Josiah
11
Slide the holder back in place. Make sure it’s locked!
Make sure the chip contacts are on the correct side as shown.
www.iRecyclingTimes.com|Issue71