Questions And Answers PDF
Cisco 300-115 Implementing Cisco IP Switched Networks (SWITCH )
Version: DEMO
http://www.TestWarrior.com/300-115-practice-exam.html
FOR 300-115 Candidates: We offer Two Products: 1st - We have Practice Tests Software with Actual Exam Questions 2nd - Questions and Answers in PDF Format. Try a Free DEMO of these Exam Products via below Link:
http://www.TestWarrior.com/300-115-practice-exam.html
TestWarrior.com
1
Questions And Answers PDF
Version: 15.0 Question 1 What is the maximum number of switches that can be stacked using Cisco StackWise? A. 4 B. 5 C. 8 D. 9 E. 10 F. 13
Aoswern D Question 2 A network engineer wants to add a new switch to an existng switch stack. Which confguraton must be added to the new switch before it can be added to the switch stack? A. No confguraton must be added. B. stack ID C. IP address D. VLAN informaton E. VTP informaton
Aoswern A Question 3 What percentage of bandwidth is reduced when a stack cable is broken? A. 0 B. 25 C. 50 D. 75 E. 100
Aoswern C Question 4 Refer to the exhibit.
TestWarrior.com
2
Questions And Answers PDF
Which set of confguratons will result in all ports on both switches successfully bundling into an EtherChannel? A. switch1 channel-group 1 mode actie switch2 channel-group 1 mode auto B. switch1 channel-group 1 mode desirable switch2 channel-group 1 mode passiie C. switch1 channel-group 1 mode on switch2 channel-group 1 mode auto D. switch1 channel-group 1 mode desirable switch2 channel-group 1 mode auto
Aoswern D Question 5 Refer to the exhibit.
TestWarrior.com
3
Questions And Answers PDF
How can the trafc that is mirrored out the GigabitEthernet0/48 port be limited to only trafc that is receiied or transmited in VLAN 10 on the GigabitEthernet0/1 port? A. Change the confguraton for GigabitEthernet0/48 so that it is a member of VLAN 10. B. Add an access list to GigabitEthernet0/48 to flter out trafc that is not in VLAN 10. C. Apply the monitor session flter globally to allow only trafc from VLAN 10. D. Change the monitor session source to VLAN 10 instead of the physical interface.
Aoswern C Question 6 Refer to the exhibit.
A network engineer wants to analyze all incoming and outgoing packets for an interface that is connected to an access switch. Which three items must be confgured to mirror trafc to a packet snifer that is connected to the distributon switch? (Choose three.) A. A monitor session on the distributon switch with a physical interface as the source and the remote SPAN VLAN as the destnaton B. A remote SPAN VLAN on the distributon and access layer switch C. A monitor session on the access switch with a physical interface source and the remote SPAN VLAN as the destnaton D. A monitor session on the distributon switch with a remote SPAN VLAN as the source and physical interface as the destnaton E. A monitor session on the access switch with a remote SPAN VLAN source and the physical interface as the destnaton F. A monitor session on the distributon switch with a physical interface as the source and a physical interface as the destnaton
Aoswern B, C, D
TestWarrior.com
4
Questions And Answers PDF
Question 7 Afer an EtherChannel is confgured between two Cisco switches, interface port channel 1 is in the down/down state. Switch A is confgured with channel-group 1 mode actie, while Switch B is confgured with channel-group 1 mode desirable. Why is the EtherChannel bundle not working? A. The switches are using mismatched EtherChannel negotaton modes. B. The switch ports are not confgured in trunking mode. C. LACP priority must be confgured on both switches. D. The channel group identfer must be diferent for Switch A and Switch B.
Aoswern A Question 8 An EtherChannel bundle has been established between a Cisco switch and a corporate web serier. The network administrator notced that only one of the EtherChannel links is being utlized to reach the web serier. What should be done on the Cisco switch to allow for beter EtherChannel utlizaton to the corporate web serier? A. Enable Cisco Express Forwarding to allow for more efectie trafc sharing oier the EtherChannel bundle. B. Adjust the EtherChannel load-balancing method based on destnaton IP addresses. C. Disable spanning tree on all interfaces that are partcipatng in the EtherChannel bundle. D. Use link-state tracking to allow for improied load balancing of trafc upon link failure to the serier. E. Adjust the EtherChannel load-balancing method based on source IP addresses.
Aoswern E Question 9 Interface FastEthernet0/1 is confgured as a trunk interface that allows all VLANs. This command is confgured globally: monitor session 2 flter ilan 1 - 8, 39, 52 What is the result of the implemented command? A. All VLAN trafc is sent to the SPAN destnaton interface. B. Trafc from VLAN 4 is not sent to the SPAN destnaton interface. C. Filtering a trunked SPAN port efectiely disables SPAN operatons for all VLANs. D. The trunk's natie VLAN must be changed to something other than VLAN 1. E. Trafc from VLANs 1 to 8, 39, and 52 is replicated to the SPAN destnaton port.
Aoswern E Question 10 A network engineer notces inconsistent Cisco Discoiery Protocol neighbors according to the
TestWarrior.com
5
Questions And Answers PDF
diagram that is proiided. The engineer notces only a single neighbor that uses Cisco Discoiery Protocol, but it has seieral routng neighbor relatonships. What would cause the output to show only the single neighbor? A. The routers are connected iia a Layer 2 switch. B. IP routng is disabled on neighboring deiices. C. Cisco Express Forwarding is enabled locally. D. Cisco Discoiery Protocol adiertsements are inconsistent between the local and remote deiices.
Aoswern A Question 11 Afer the implementaton of seieral diferent types of switches from diferent iendors, a network engineer notces that directly connected deiices that use Cisco Discoiery Protocol are not iisible. Which iendor-neutral protocol could be used to resolie this issue? A. Local Area Mobility B. Link Layer Discoiery Protocol C. NetFlow D. Directed Response Protocol
Aoswern B Question 12 Seieral new switches haie been added to the existng network as VTP clients. All of the new switches haie been confgured with the same VTP domain, password, and iersion. Howeier, VLANs are not passing from the VTP serier (existng network) to the VTP clients. What must be done to fx this? A. Remoie the VTP domain name from all switches with "null" and then replace it with the new domain name. B. Confgure a diferent natie VLAN on all new switches that are confgured as VTP clients. C. Proiision one of the new switches to be the VTP serier and duplicate informaton from the existng network. D. Ensure that all switch interconnects are confgured as trunks to allow VTP informaton to be transferred.
Aoswern D Question 13 Afer implementng VTP, the extended VLANs are not being propagated to other VTP switches. What should be confgured for extended VLANs? A. VTP does not support extended VLANs and should be manually added to all switches. B. Enable VTP iersion 3, which supports extended VLAN propagaton. C. VTP authentcaton is required when using extended VLANs because of their ability to cause network instability.
TestWarrior.com
6
Questions And Answers PDF
D. Ensure that all switches run the same Cisco IOS iersion. Extended VLANs will not propagate to diferent IOS iersions when extended VLANs are in use.
Aoswern B Question 14 Refer to the exhibit.
Switch A, B, and C are trunked together and haie been properly confgured for VTP. Switch C receiies VLAN informaton from the VTP serier Switch A, but Switch B does not receiie any VLAN informaton. What is the most probable cause of this behaiior? A. Switch B is confgured in transparent mode. B. Switch B is confgured with an access port to Switch A, while Switch C is confgured with a trunk port to Switch B. C. The VTP reiision number of the Switch B is higher than that of Switch A. D. The trunk between Switch A and Switch B is misconfgured.
Aoswern A Question 15 Refer to the exhibit.
Switch A, B, and C are trunked together and haie been properly confgured for VTP. Switch B has all VLANs, but Switch C is not receiiing trafc from certain VLANs. What would cause this issue? A. A VTP authentcaton mismatch occurred between Switch A and Switch B. B. The VTP reiision number of Switch B is higher than that of Switch A. C. VTP pruning is confgured globally on all switches and it remoied VLANs from the trunk interface that is connected to Switch C. D. The trunk between Switch A and Switch B is misconfgured.
TestWarrior.com
7
Questions And Answers PDF
Aoswern C
TestWarrior.com
8
Questions And Answers PDF
Thank You for Trying Our Product Visit Our Site to Purchase the Full Set of Actual 300-115 Exam Questions With Answers.
http://www.TestWarrior.com/300-115-practice-exam.html We Also Provide Practice Exam Software That Simulates Real Exam Environment And Has Many Self-Assessment Features. Download Free Product Demo From:
Download Free Product Demo from: http://www.TestWarrior.com/300-115-practice-exam.html
Check Out Our Customer Testimonials
TestWarrior.com
9