SINGLE-PORT DIGITAL GARDEN WATER TIMER
QUICK START GUIDE REMASTERED BY
INFORMATION This garden timer has a built in moisture sensor to avoid wasting water. If it’s been raining and there is water is in the rain collector then the timer will briefly start and turn off again. It will remain off until the collector is empty and will activate again depending on your next configured timer settings. When being used outside the water tight plastic cover for the liquid-crystal display must be kept on at all times otherwise moisture may get inside and damage the electronics. After timer settings have been configured the mode is set to ‘Auto’ and the timer function can be started. Do not use the timer outside during extreme winter conditions or freezing temperatures. For safety reasons the garden water timer settings will only work once the LCD screen is in locked mode. timer has an automatic child safety lock that disables the function buttons. If the device is locked you'll see a back-tofront ‘6’ at the bottom left of the LCD. To unlock the timer press the ‘del’ button 3 times. PAGE 2
aizbo-online.com
SETTING THE TIME
Before you get started with the timers you’ll need to set the correct time first. 1) Click the ‘time’ button once. This will make sure you are in the time mode. 2) Click the ‘wk’ button to select the day of the week. The days appear at the top of the LCD and are in Chinese but from left to right they translate to: MON – TUE – WED -THU – FRI – SAT – SUN
3) Click the ‘hr’ button to set the hour. It is in 24 hour format so continue to press to go from 00 to 23 4) Click the ‘min’ button to set the minute. You can repetitively press the button to go from 00 to 59 or hold the button down to speed up the process. 5) Click the ‘time’ button once finished to confirm your timer settings and return to the time screen
aizbo-online.com
PAGE 3
SETTING THE TIMER Press the ‘set’ button once to enter the timer mode. The screen will show ‘1 开’ (Timer 1: Open) at the bottom left of the LCD. This is the first set of times and represents when the water should turn on. Set up the timer by pressing the ‘wk’ button to select a day, and the ‘hr’ and ‘min’ button select the time. You can adjust the values by continuously clicking the button or press down to
PAGE 4
speed things up. Press the ‘set’ button again and the screen shows ‘1 关‘ (Timer 1: Close). This will be the time that the water should be turned off. Again, set up the timer by pressing the ‘wk’ button to select a day, and the ‘hr’ and ‘min’ button select the time. You can adjust the values by continuously clicking the button or press down to speed things up.
aizbo-online.com
READY TO GO That’s it, the first timer has now been setup. You can do this up to 18 times, to set up a second timer click the ‘set’ button until you see the ‘2 开 ' (Timer 2: Open). Once finished click the ‘time’ button to go to the main display screen.
MANUAL MODE If you need to use the water supply when the timers are of then you can deactivate the auto timers by clicking ‘manual’. Once you have finished click ‘manual’ again and it will go back to you configured timer settings one it goes into locked mode.
TRANSLATIONS
aizbo-online.com
PAGE 5
www.aizbo-online.com