A02 interim

SARAH CHAN -­‐ 641728

Structural Concept

3

1

4

2

GUEST STUDIO MURCUTT

PLAN

These drawings are from an architect, Glenn Murcutt, who uses hand sketches to portray his

designs. This particular work was designed as a guest studio located New South Wales.

The section that was selected for us to construct a 1:1 structure was the bathroom. The into four sections: top right, bottom right, top left and bottom left. My bathroom was spit group was appointed to section 4.

The purpose of this activity is to build a full size section of the selected area using the drawings provided.

VERTICAL SECTION CUT

SARAH CHAN -­‐ 641728

MATERIALS: -­‐ -­‐ -­‐ -­‐ -­‐ -­‐ -­‐ -­‐ -­‐ -­‐ -­‐ -­‐ -­‐ -­‐ -­‐ -­‐ -­‐ -­‐ -­‐

STRUCTURES TO LOOK AT:

Steel Timber glass zinalume (zinc & aluminium) insulation for roof/walls brass/stainless steel (won’t melt) bolts steel roof sheets/cladding timber stumps rafters (for roofing) battens (roofing) box gutter downpipe rain water head (RWH) plaster boards (living room) villa board (used when there’s wet areas) plywood timber ceiling nails/screws

-­‐ -­‐

NOGGINGS – horizontal beams on different levels for practical reasons. Can be nailed in easily and stops vertical walls from breaking

STUDS – vertical; smaller than posts

cantilever skillion roof

SARAH CHAN -­‐ 641728

In the first week of ‘Built Detail’, we were introduced to the drawings and designs of Glenn Murcutt who is an Australian architect. Even though he produces residential and institutional work over Australia, most of them are based in New South Wales. His works are not only known within Australia, but it also has a worldwide influence.

Murcutt Guest Studio, Kempsey (NSW): -­‐ built in 1992 -­‐ he used an existing old house that was already there

The drawings that were included had plans and elevated diagrams that explained some of the materials required as well as the dimensions. After getting familiar with his drawings, we had to come up with a list of materials that would need to be purchased to build the section that was chosen.

In our second workshop, we were split into four groups, where each group was allocated with a portion of the selected area of the drawing that happened to be the bathroom area.

We used a scaled ruler to figure out the drawing’s dimensions and drew it on a large plank of wood. The marking made on it would later be cut, therefore are used as guidelines. Each individual group had their own areas to draw their 1:1, and later we would have to conjoin the top and bottom walls, therefore it was important for us to measure correctly in order to join the walls together.