DIGITAL DESIGN + FABRICATION SM1, 2015 M1 JOURNAL - YOUR PROJECT TITLE KEVIN SEK
638985 Michelle James Grp Mon 3.15-5.15pm
1
Measured Drawings
83mm
47mm
113mm
PLAN (scale 1:1) The object used was an Egg Slicer. First the outline was traced by placing object on top of paper. Then measurements were made using a ruler to fill in the outline as accurately as possible.
2
ELEVATION AND SECTION (scale 1:1)
11mm
22mm
11mm
25mm
For the elevation and section measured drawings, images of the real object were taken along with a ruler for scale, reprinted and then traced over using tracing paper. Measurements were then made with a ruler.
54mm
118mm
83mm
3
Analysis
Supporting base without hinges
Plan depicting alignment of cutting wire and base of Egg Slicer. Eggs can be placed horizontally or vertically.
The Egg Slicer is constructed of common industrial materials. The base is made of mouldable plastic allowing for commercial mass production while the “lid� and wires are made of metal for its edge and durability allowing it to easily slice through an egg. There is a raised central platform also made of plastic which consists of eliptical indents that allows an egg to be placed either vertically or horizontally. The base of the egg slicer can be seperated into 3 main components. The supporting base, the hinges and the central platform. The central platform can be furthur seperated into 9 discrete sections, but consist of essentially repeats of sections A - E. These are depicted in the diagrams to the right and the following pages.
4
Central platform with eliptical indentations and sections A - E
Hinges x 2
C.
Hinge mechanism which allows for free 180 degrees rotation
A.
B.
D.
E.
5