VIS128FBUG-12 UPGRADE KIT
READ ME FIRST! THIS UPGRADE KIT IS APPLICABLE TO THE VISTA-128FB ONLY. IF USING THE VGM WITH A DIFFERENT ALARM PANEL, SEE THE NOTE AT THE BOTTOM OF THIS PAGE. To use the VGM with the VISTA-128FB alarm panel, the panel revision level must be Rev. Level 02 or greater. Obtain the revision level of the panel by entering the program mode and entering #92. If you do not have a revision level of 02 or greater, use these instructions and the enclosed EPROM (P/N WAVIS128-12FB) to upgrade the panel. 1. Remove all power (AC transformer and battery) from the VISTA-128FB control. 2. To guard against any “static discharge” damage during the upgrading process, briefly touch the ground terminal (#30) in the VISTA-128FB control cabinet to discharge any static buildup. NOTE: Avoid performing this upgrade while standing on a carpeted floor. Performing this upgrade on a carpeted floor will increase the possibility of static buildup. 3. Remove the metal cover that shields the VISTA128FB EPROM. 4. Locate the existing VISTA-128FB EPROM (see Figure 1). 5. Using an IC removal tool, or similar device, carefully remove the EPROM by slowly prying the EPROM out of its socket (see figure 2). NOTE: If
using a screwdriver, insert the screwdriver between the socket and the EPROM and slowly pry the EPROM out alternating from one end of the EPROM to the other. 6. Carefully insert the new EPROM from the upgrade kit into the empty socket. Be sure to correctly orient the EPROM with the “notch” pointing toward the left as shown in figure 1. Be careful not to bend or break any of the EPROM pins while inserting it. 7. Replace the metal cover that shields the EPROM observing the “This Side Up” reference. 8. Restore power to the control. 9. Enter the programming mode (enter installer’s code + 8 + 0 + 0 + 0). 10. Reload the factory defaults by pressing *97. 11. After the control finishes loading the defaults, exit the programming mode by pressing *99.
EPROM
VISTA-128FB PC BOARD
SCREWDRIVER EPROM IC SOCKET PC BOARD
FIgure 2 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30
TERMINAL STRIP
Figure 1
NOTE: IF USING THE VGM WITH A PANEL OTHER THAN THE VISTA-128FB, DO NOT INSTALL THE EPROM IN THIS UPGRADE KIT. COMPATIBLE REVISION LEVELS AND EPROM PART NUMBERS FOR OTHER PANELS ARE AS FOLLOWS: REVISION PANEL EPROM PART NUMBER (for compatible revision levels) LEVEL VISTA-128B 1 WAVIS128-11B VISTA-120 4 WAVIS120-14 FA-1600C 6 WAVIS150-16FA
165 Eileen Way, Syosset, New York 11791 Copyright © 1999 PITTWAY CORPORATION
¬. 50)Zl K3900RMF 3/99
VIS128FBUG-12