Contents of the box:
Features: Alphanumeric Keyboard
Features: Back Battery compartment Stylus
Scan key
Microphone
Getting Started [FN/BLUE] key
1
Unlatch and open the battery compartment.
2
Insert the battery.
3
Close and latch the battery compartment.
Hand-He
ld Com pute
r
September
NEO Hand-Held Computer
PN: 8100 158.A
EULA documents
Scanner window
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
Q
R
S
T
UVW
XYZ
P
Features: Battery Compartment
Features: Front Receiver
Features: Numeric Keyboard
Battery cover Display
[ENTER]/ Power key
Expansion-port cover
This Guide
Lanyard
LED indicator
[FN/ORANGE] key
ISO 9001 Certified Quality Manage ďż˝ ment System
Wrist strap Battery
30, 2008
Battery cover latch
Beeper
[ENTER]/Power key Keyboard
MicroSD Card holder
Accessory attachment point Microphone Accessory attachment point
Docking port Beeper
Battery contacts
Accessory attachment point
Microphone
Scan key [FN/BLUE] key
[FN/ORANGE] key [ENTER]/ Power key
Battery-detection magnet (inside battery cover) Serial number label
$
Over
4
Charge the battery. Insert the NEO into a Docking Station or connect a charger.
To suspend the NEO, do either of the following:
Hand-Held Computer
Note: During charge, the LED indicator on the NEO is YELLOW until charging reaches 75%. Between 75% and 95% the indicator flashes GREEN slowly, and, above 95%, the indicator is GREEN continuously. The LED indicator on the Docking Station behaves the same when a spare battery is being charged.
Resetting the NEO
Allow the NEO to charge for three hours before first use.
41 - 104 °F
5
3h
Quick Start Guide
Important: Resetting the unit may result in data loss.
Note: Use only the universal AC power supply approved by Psion Teklogix for use with the Docking Station.
5 - 40 °C
™
• Press and release the [FN/BLUE] key, then press the [ENTER] key. • Select Shutdown, then select Suspend from the Start menu.
September 30, 2008
To warm-reset the NEO: • Press the [BLUE] and [ENTER] keys simultaneously for six seconds, or • Select Shutdown, then select Warm Reset from the Start menu.
Note: Full battery performance is only reached after the first few charge/discharge cycles.
Turn the unit on. Press the [ENTER]/Power key for two seconds. [ENTER]/ Power key
[ENTER]/ Power key
Psion Teklogix and NEO are trademarks of Psion Teklogix Inc. Other product names mentioned in this document are trademarks or registered trademarks of other hardware, software, or service providers and are used herein for identification purposes only.
*8100158* 8100158 Rev. A
ISO 9001 Certified Quality Management System
PN: 8100158.A