Exam JN0-522 preparation questions

Exam JN0-522 study material Made available by Testkingprep.com

Free JN0-522 Exam Preparation Questions Exam JN0-522: FXV, Associate (JNCIA-FWV)

For Latest JN0-522 Exam Questions and study guides- visit- http://www.testkingprep.com/JN0-522.html

Question:1 A ScreenOS firewall is running in transparent mode. The firewall receives a packet which has no entry in its forwarding table. What will the firewall do?

A. Flood out all ports.

B. Check its route table for interzone destination.

C. Perform a policy lookup to determine the interfaces to which the source address is permitted, and flood the packet out of those interfaces.

D. Perform a policy lookup to determine the zones to which the source address is permitted, and flood the packet out the interfaces bound to those zones.

Answer: D Question:2 Click the Exhibit button.

Which ScreenOS CLI command would allow all policies in the exhibit to match traffic?

A. Set policy 4 before 1 B. Exec policy 4 before 1 C. Insert policy 4 before 1 D. Set policy move 4 before 1 Answer: D Question:3 You enter the following command: set int e0/8 mip 1.1.8.32 host 10.1.10.32 netmask 255.255.255.248 How many MIP address translations have you just configured?

A. 1 B. 8 C. 32 D. 254 Answer: B Question:4 Which process describes how an addressed physical interface is moved into a Layer 2 zone?

A. Place the required interface into the VLAN zone.

B. Place the required interface into L2 zones such as V1-Trust, V1-Untrust C. Remove the interface from the L3 zone such as Trust and place it into a L2 zone such as V1-Trust D. Remove the address from the interface, remove the interface from the L3 zone, and then place interface in the L2 zone.

Answer: D Question:5 If all interfaces are configured for route mode, what will be modified by the ScreenOS device when traffic travels from the trust zone to the untrust zone?

For Latest JN0-522 Exam Questions and study guides- visit- http://www.testkingprep.com/JN0-522.html

A. Source IP B. Source port C. Source MAC D. Destination IP E. Destination port Answer: C Question:6 In transparent mode, you can create policies between which zones?

A. untrust and V1-Trust B. private and L2-public C. V1-Trust and private (L2) D. V1-Untrust and L2-private Answer: D Question:7 When adding an address book entry for a host, which mask should be used?

A. 0.0.0.0 B. 255.255.255.0 C. 255.255.255.255 D. The host's subnet mask i.e., 255.255.255.224 Answer: C Question:8 While looking at your policies using the WebUI, you notice that the green permit policy has turned blue.

What would cause this?

A. The policy is currently inactive.

B. The policy is configured to support a MIP. C. The policy is configured for unidirectional NAT. D. The policy is currently passing traffic beyond its traffic limits and is in alarm state.

Answer: C Question:9 Click the Exhibit button. In the exhibit, you need to make a bidirectional VPN between the SSG 5 and the SSG 550. On the SSG550, which address will you use to configure the IKE gateway?

A. 10.0.0.1 B. 20.0.0.1 C. 1.1.1.250 D. 4.4.4.250 Answer: C Question:10

For Latest JN0-522 Exam Questions and study guides- visit- http://www.testkingprep.com/JN0-522.html

Which two commands do you use to verify that you have a route available to host 1.1.1.5 on your ScreenOS device? (Choose two.)

A. trace-route B. get interface C. get route 1.1.1.5 D. get route ip 1.1.1.5 Answer: A, D

For Latest JN0-522 Exam Questions and study guides- visit- http://www.testkingprep.com/JN0-522.html

For complete Exam JN0-522 Training kits and Self-Paced Study Material Visit: http://www.testkingprep.com/JN0-522.html

http://www.testkingprep.com/

For Latest JN0-522 Exam Questions and study guides- visit- http://www.testkingprep.com/JN0-522.html