Fitting Instructions
TOWBAR HY33A For Hyundai Getz 2002- 2005
MATERIALS A 1 Cross Bar with European facing to 94/20/EC A50-1 D 4 M12 x 45 x 1.25mm Bolts, Lock Washers and Flat Washers (30mm O.D. x 4 mm) E 1 Spacer CB 2 M16 x 40mm Coupling Bolts, Nuts, Lock Washers Z 1 ZEP35 Electrical plate (not shown) FITTING 1. Remove the bumper by: • Disconnecting the fog light at the socket attached to the rear valance and detach the socket from the valance. • Removing the four bolts holding the bumper rail to the rear valance. (2 bolts located behind valance at either side of each chassis rail. • Removing the four upper securing screws and the lower centre and outer plastic plugs. (3 plugs total) • Removing the screws securing the lower edges of the mudguards to the bumper. • Removing the bolts securing each top corner of the bumper to the rear wheel arches. • Pulling the bumper off the location clips situated behind the top edge of the bumper, at each end. 2. Lift the cross bar (A) into position so that it is located against the chassis rails as shown below. Loosely attach to the nearside chassis rail using fasteners (D). Align the right hand end of the cross bar to the mounting holes and loosely attach with fasteners (D) and spacer (E), taking care to orientate spacer as shown below. 3. Refit the bumper assembly to its location clips ensuring the socket for the fog light is suitably located near its plug, (Note: Protect lower edge of bumper whilst refitting over cross bar.) 4. Refit the bumper and mudguard screws and plugs in the reverse order to above. 5. Finally tighten all bolts securing the cross bar, starting with the left hand side. Note: This towbar must be used with either a Witter Towball (part number Z1) or Class A50-1 or A50-X towball dimensionally Conforming to A50-1 with a ‘D’ and 'S' value greater than or equal to that of the towbar. Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed. Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
WITTER TOWBARS Deeside Ind. Park, Deeside, CH5 2NY
witter-towbars.co.uk
µW0001HY33A-FIT$021103170000*Ä W0001HY33A-FIT$021103170000
Issue 2