Gateway
Installation Manual
Version 1.2 09/04/2015
English
In box: M12 Cable Gland
2 x Product ID Sticker
5m Cable
You’ll need: Drill
M12 Thread
Generic Strap x 2
Max = 13mm Min = 8mm
Page 2 of 7
1. Run wire through cable gland
2. Drill M12 threaded hole into back of pole
5m
Page 3 of 7
3. Run wire through hole
4. Screw cable gland in hole Rotate the cable gland to tighten
Page 4 of 7
5. Strap product to pole Tensioning Tool THIS SIDE UP
* Ensure Tensioning Tool is set to maximum tension (# 4)
6. Apply product ID sticker to pole Ensure ID sticker of product and pole are the same
SAME
5 cm
Page 5 of 7
Wiring Diagram
WARNING: If not correctly connected product will not function.
AC in(N)
AC in(L)
AC in(N)
AC in(L)
Junction Box
Page 6 of 7
Wiring Diagram Armature (Armatuur) L N GND
WARNING:
Tvilight Gateway
If not correctly connected product will not function.
L
N
Junction Box (Aansluitset) L N L N GND
GND AC In(L)
AC In(N )
Blue Brown
AC1 AC2 AC3
To Mains (Naar Mains)
Note: For added protection, it is recommended to add an external circuit breaker at the power input of the product. Circuit breakers such as the TYCO W33-S1N1Q-20 or similar rated products could be used.
Page 7 of 7