Gateway - Installation Manual - Grommet

Gateway

Installation Manual

Version 1.2 09/04/2015

English

In box: Rubber Grommet

2 x Product ID Sticker

5m Cable

You’ll need: Drill

16mm

Generic Strap x 2

Max = 13mm Min = 8mm

Page 2 of 7

1. Run wire through grommet

2. Drill 16mm hole into the back of pole

5m

Page 3 of 7

3. Run wire through hole

4. Push grommet into hole Use a screw driver to press grommet into the hole

Page 4 of 7

5. Strap product to pole Tensioning Tool THIS SIDE UP

* Ensure Tensioning Tool is set to maximum tension (# 4)

6. Apply product ID sticker to pole Ensure ID sticker of product and pole are the same

SAME

5 cm

Page 5 of 7

Wiring Diagram

WARNING: If not correctly connected product will not function.

AC in(N)

AC in(L)

AC in(N)

AC in(L)

Junction Box

Page 6 of 7

Wiring Diagram Armature (Armatuur) L N GND

WARNING:

Tvilight Gateway

If not correctly connected product will not function.

L

N

Junction Box (Aansluitset) L N L N GND

GND AC In(L)

AC In(N )

Blue Brown

AC1 AC2 AC3

To Mains (Naar Mains)

Note: For added protection, it is recommended to add an external circuit breaker at the power input of the product. Circuit breakers such as the TYCO W33-S1N1Q-20 or similar rated products could be used.

Page 7 of 7