Vintaj Filigree Window

V I N TA J D . I .Y B A S I C S

WINDOW FILIGREE What you’ll need: Fanned Boho Filigree Regalia Layering Window 25x18mm Oval Cabochon E6000 Adhesive Chain Nose Plier

1

Apply E6000 Adhesive to the back flat side of cabochon.

3

Position the opening of layering window over cabochon to check placement and determine where you will form ends.

22

Place cabochon over center of boho filigree. Carefully lay onto a flat surface. Allow to dry a few hours.

4

Use chain nose plier to grip near the ends of the layering window, approximately 3/8� from tip. Bend to a 90 degree angle towards the back of the piece.

51

Hold at the center of each end. Gently curve to form the shape of stone. Do not bend directly at center of window.

7

Ends of layering window should fit just below the second loop of fanned filigree.

While holding piece at the center, use chain nose plier to continue folding over the ends of layering window around the back side of filigree. Crimp both ends down at the center and sides until secure.

62

Slip layering window up over the boho filigree and stone. Use plier to gently open ends of layering window if needed.

8

Use chain nose plier to gently form front of layering window around the shape of the stone, both at the top and the bottom.

Create beaded drops for all 5 loops from the bottom of the filigree. Attach drops with a jump ring and simply add chain to complete your necklace.